Kohler 18RESHD Instrukcja instalacji - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Przenośny generator Kohler 18RESHD. Kohler 18RESHD 40 stron. Residential/commercial generator sets
Również dla Kohler 18RESHD: Działanie (48 strony)

Drukuj stronę

This manual provides installation instructions for 12, 17,

and 18 kW residential/commercial generator sets

equipped with the Kohlerr DC-RET Digital Control.

Refer to TP-6517, Operation Manual, for generator set

operation and maintenance instructions.

The generator set is approved for use in stationary

applications in locations served by a reliable utility

power source.

Have an authorized distributor/dealer install the

generator set outdoors according to the instructions in

this manual. The generator set installation must comply

with the National Electrical Code (NEC) and local code

requirements. Do not install this generator set indoors.

1. Muffler

2. Oil check

3. Oil fill

4. Air cleaner

5. Fuses

6. RS-232 connector (for application program updates)

7. Controller user interface

8. Generator set master switch (RUN-OFF/RESET-AUTO)

9. Load circuit breaker

10. Field-connection terminal block location

11. Spark plug locations (both sides)

12. Oil drain hose

13. Oil drain valve

Figure 1 Generator Set Component Locations, 12 kW Models

TP-6516 4/09

5 6

Information in this publication represents data available

at the time of print. Kohler Co. reserves the right to

change this publication and the products represented

without notice and without any obligation or liability

whatsoever.

Read this manual and carefully follow all procedures

and safety precautions to ensure proper equipment

operation and to avoid bodily injury. Read and follow the

Safety Precautions and Instructions section at the

beginning of this manual.

See Figure 1 or Figure 2 for generator set component

locations.

14. Oil filter

15. Exhaust

16. Equipment ground

17. Battery charger

18. DSAI lead location

19. LP fuel orifice location

20. Gas regulator assembly

21. Fuel solenoid valve

22. Fuel inlet

23. Air intake

24. Engine starting battery location

(battery purchased separately)

Introduction

See

Detail

Fuel system detail

ADV-7466-