Acala Advanced Instrukcja obsługi - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Systemy filtracji wody Acala Advanced. Acala Advanced 11 stron. Table water filters

Situation: The water has an unusual smell or taste.

Cause:

1. Poor quality water has been used, such as water containing sulfur or with high manganese content

2. The filtering cartridge or the lime filter has been used up.

3. The mineral stones give off an intense taste, because they may

a) have been freshly installed and not yet boiled,

b) do not harmonize with the water used or you do not like the taste influence of the mineral stones

in the long term.

4. Too little water has been filtered.

5. Too many mineral stones are in the lower tank.

Solution:

1. a) Filter the same water a second time.

b) Check again the quality of the water you use with the system.

2. Replace the filtering cartridge.

3. Replace the optional limescale filter or replace the contents (see assembly instructions of the lime

filter).

4. Filter 20-30 litres of water and make sure that there is a use of the water system with more than 6

litres per day.

5. a) You may use less or no mineral stones if you do not like the taste for a long time or if the

mineral stones do not harmonize with the water.

b) Boil the mineral stones in salt water.

Situation: Green spots or coating appears on the ceramic filter, in the upper tank, and possibly also

in the drinking water tank.

Cause:

Your water filter is in a too bright location. Algae spores are, as well as pollen, always and

everywhere around us. If algae spores meet water in combination with light, algae growth is

promoted.

This coating is usually harmless to health.

Solution:

1. Do not place your water filter near a light source. Darken it with an Acala light

protector/overhang adapted to your table filter.

2. Clean the entire system promptly and remove the green spots.

3. Boil the mineral stones with natural salt.

4. If the algae have already spread to the cartridge, change all filter components.

5. After cleaning, put the AcalaQuell® back into operation and filter at least 6 litres of water per

day.