AQmatic NX51 Instrukcja serwisowa - Strona 9
Przeglądaj online lub pobierz pdf Instrukcja serwisowa dla Kontroler AQmatic NX51. AQmatic NX51 18 stron. Nxt stager controller
Drukuj stronę
USER PROGRAMMING MODE FLOW
CHART
Entering User Programming Mode
Hold the Up and Down buttons for 5 seconds.
FEED WATER
HARDNESS:
gpg
Options: U.S. Format
[gpg]
Metric Format
[mgL]
REGENERATION DAY
OVERRIDE: OFF
Options: U.S. Format
[OFF] = default
Metric Format
[OFF] = default
REGENERATION DAY
OVERRIDE:99 DAYS
REGENERATION
TIME:
02:00AM
Options: U.S. Format
[02:00AM] = default
Metric Format
[02:00] = default
DIAGNOSTIC PROGRAMMING MODE
FLOW CHART
Entering Diagnostic Programming Mode
1. Push and release the "D" button.
2. Press the Extra Cycle button once per display until all
displays are viewed and Normal Display is resumed.
3. Push and release the"D" button at anytime during
diagnostic mode and the timer will exit the mode.
4. Depending on the current controller programming, certain
displays may not be able to be viewed or set.
CURRENT FLOW
RATE:
0 gpm
Explaination: Flow rate at this time.
PEAK FLOW RATE:
0 gpm
Explaination: Peak flow since last regeneration.
TOTALIZER:
130 g
Explaination: Gallons at the outlet since installation.
LAST TWO REGENS:
0 HOURS
Explaination: Hours between the last regeneration and the one before it.
LAST REGEN
0 HOURS
Explaination: Hours since last regeneration.
VOLUME REMAIN:
1000 g
Explaination: Volume remaining; can be adjusted.
VALVE ADDRESS
#2
Explaination: Controller unit number.
VERSION:
X.XX
Explaination: Installed software level of the controller in use.
NXT Stager Controller AU11