Aqua KID ECO P2 Skrócona instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Systemy filtracji wody Aqua KID ECO P2. Aqua KID ECO P2 8 stron.

- Do not use in presence of water with unknown origin or microbiologically not pure, without providing
for the use of an adequate disinfection system;
- Use the filters in compliance with the operating pressures declared by the manufacturer. With
presence of high pressures in the circuit or "water hammer", protect the device by installing a
pressure reducer upstream;
- Except for special filters, use the filters with liquids at room temperature (20-25°C), however within
the limits indicated by the manufacturer. If used upstream of a boiler, it is recommended to install a
non-return valve to prevent boiling water from entering the filter;
- Do not use the containers for the filtration of compressed air, oil or gas, even at low pressures.
- Do not use these filters in environments exposed to freezing temperatures or high temperatures.
Therefore, installation outdoors or in places exposed to bad weather or ultraviolet rays is not
recommended;
- This equipment requires regular periodic maintenance in order to ensure the maintenance of the
drinking water requirements of the treated water.

INSTALLATION

The installation of the filter must be performed by qualified personnel capable of issuing a regular
declaration of conformity.
The typical filter assembly scheme is the
one shown in the image alongside.
It is advisable to create a bypass to
ensure maintenance of the filter cartridge
without eliminating the supply of water to
the users.
During the assembly phase it is important
to respect the inlet / outlet direction (IN-
OUT) indicated on the filter head. This is necessary to allow the cartridges to work correctly.
IMPORTANT: The AQUA KID filter head is equipped with a double inlet: one horizontal and one
vertical. Use the one that best suits the circuit and remember to put the appropriate cap in the unused
inlet.
To install the filter on the wall, use the appropriate wall bracket (optional), which allows for correct
fixing and proper spacing from the wall, necessary to ensure the opening of the filter with the use of
the appropriate key.