Aqua Computer poweradjust 3 Instrukcja obsługi i instalacji - Strona 15

Przeglądaj online lub pobierz pdf Instrukcja obsługi i instalacji dla Kontroler Aqua Computer poweradjust 3. Aqua Computer poweradjust 3 20 stron. Usb unit is a high power fan or pump controller for pcs

Drukuj stronę

aqua

computer

POWERADJUST 3

signal. Alternatively, the speed signal output can be configured as a switching out-

put. The check boxes "Switch off speed signal in case of alarm condition" and "In-

vert output behavior" determine output behavior during alarm conditions.

Option "Power switch (53217)": This mode can be used for emergency shutdown

of the PC, if the speed signal/RPM header is connected to the power switch header

of the motherboard using a suitable cable (art. 53217). Before connecting the ca-

ble, make sure the poweradjust is configured correctly! After connecting the cable,

test the setup by deliberately creating an alarm condition. If the PC is not shut

down, the cable header connected to the motherboard must be rotated by 180

degrees and the test has to be repeated. Emergency shutdown may result in data

loss as operating system and running programs are not shut down properly!

10.2. Alarm reporting and alarm limits

Select the data sources to be monitored and set appropriate alarm limits. If the

current reading is below the lower limit or higher than the upper limit, an alarm

will be raised if the check box "Activate alarm evaluation" is set for this value. All

sources that currently raise an alarm are highlighted with a red background color

in the software. Make sure only to use readings for alarm evaluation that are func-

tional with your specific setup.

11. System settings poweradjust 3 (aquasuite)

Select "System" from the device list for the device to be configured.

11.1. Device information

The details displayed here might be required when you contact our service for sup-

port.

11.2. Factory defaults

Click the button "Reset device to factory defaults" for a complete reset of all set-

tings. You will have to completely reconfigure the device after resetting it to factory

defaults!

11.3. Key management

In order to upgrade your poweradjust 3 unit to a higher version, you will need the

serial number and the device key from the "Device information" section of this

page. Order the desired upgrade from the Aqua Computer web shop and enter

serial number and device key into the "Annotations" field during the checkout

process. For your convenience, you can also click the button "Buy upgrade key" to

display a help page with all necessary information.

After receiving your activation key from Aqua Computer, enter the key to the box

labeled "Enter upgrade key" and click the "Apply" button. The poweradjust 3 unit

Aqua Computer GmbH & Co. KG

- 15 -

Gelliehäuser Str. 1, 37130 Gleichen