Aqua Computer XT USB Instrukcja obsługi i instalacji - Strona 18

Przeglądaj online lub pobierz pdf Instrukcja obsługi i instalacji dla Pompa wodna Aqua Computer XT USB. Aqua Computer XT USB 20 stron.

aqua

computer

AQUASTREAM XT

(by clicking the disk symbol in the device list) and shut down your PC. Wait for a

few seconds before turning the PC on again.

15.4. aquabus configuration and flow sensor

For ultra versions of the aquastream XT pump, the "aquabus/flow" connector of

the pump controller can be configured as an aquabus interface or as a flow

sensor input.

If the connector is configured as aquabus interface, the aquabus address of the

aquastream XT controller can be selected. Each aquabus device has to be con-

figured to a unique aquabus address. If a single aquastream XT pump is used, this

step may be skipped. Addresses 10 and 11 are available for aquastream XT

pumps.

The next setting determines which interface (USB/aquabus) of the pump controller

is to be processed with higher priority. This setting is only effective if both USB and

aquabus interface are connected at the same time. Additionally, you can select a

temperature sensor that can then be read out by an attached aquabus device.

If the "aquabus/flow" header is configured as a flow sensor input, you will be able

to set up the flow sensor input in the lower region of the screen and the current

sensor reading will be displayed.

If you make changes to the bus address or reconfigure the general functionality

(aquabus/flow sensor), the pump must be restarted for the changes to take effect.

To do so, save the configuration (by clicking the disk symbol in the device list) and

shut down your PC. Wait for a few seconds before turning the PC on again.

If you detect inaccuracies in the temperature sensor readings, you can make cor-

rections here. In general, this should not be necessary.

Click the entry „Settings" below the headline „aquasuite" to access basic settings

for language, units and start-up of the software.

Select a language from the drop down menu. After changing the language setting,

the software will have to be restarted.

Select the units to be used for temperature and flow values from the drop down

menus. After changing these settings, the software will have to be restarted.

- 18 -

Aqua Computer GmbH & Co. KG

Gelliehäuser Str. 1, 37130 Gleichen