Aqua Cooler Allure Series Instrukcja obsługi i konserwacji - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Dozownik wody Aqua Cooler Allure Series. Aqua Cooler Allure Series 9 stron.

TROUBLESHOOTING

Problem
The unit does not dispense
ambient or cold water.
Unit does not dispense cold
water.
Unit is noisy during
operation.
Water leaks from the faucet.
Water is dripping out of
the water cooler and onto
the floor.
The water being dispensed
has a strange taste.

CLEANING AND MAINTENANCE

• Remove or disconnect power before performing any maintenance or servicing the product.
• Never use detergent or chemicals to clean the water tanks.
• If dust or other exterior substance has accumulated on the condenser, wipe off with water-soaked soft cloth.
• Do not directly spray water on the surface of the product. Wipe the front and back of the product with water-
soak soft cloth.
• After cleaning the product, ensure it is completely dried before beginning use again.
Possible Cause
Unit is unplugged or main power supply is
off.
The fuse has blown.
Damaged water dispenser.
The water bottle cap is not attached properly
to the connector on the water cooler.
Over consumption of cold water in a short
time.
System malfunction.
The ventilation around the unit is insufficient.
The temperature of the water in the water
bottle is too high.
The cold water switch is in the OFF position.
Cold water baffle is not set properly.
The appliance is not level.
Unit is touching other objects.
The top portion of the faucet has come loose. Tighten the top threaded portion of the faucet.
The faucet has been damaged.
The hose connnector is not connected
properly.
The drain cap on the back is not fastened
correctly.
Crack or pin holes in the bottle.
This is not uncommon with new water
coolers. Do not worry, this is not dangerous
to your health.
Remedy
Plug the power cord into an outlet and re-
establish main power supply.
Replace the blown fuse.
Contact Aqua Cooler service team.
Connect properly. There will be a give when the
hose cap slides properly over the connector.
Wait for 15 minutes while the water cools and
try again.
Contact Aqua Cooler service team.
Ensure sufficient ventilation space around the unit.
Ensure the unit is not placed in direct sunlight or
close to other heat sources.
Switch the cold water switch to the ON position.
Secure the cold water baffle in the cold tank.
Place the unit on a level, flat surface.
Ensure the unit is standing free of any surrounding
objects.
Contact Aqua Cooler service team.
Make sure the hose connector is properly
connected.
Tighten the drain cap. If the sealing silicon
material inside the drain cap is torn or damaged,
then replcae with a new one.
Replace with a new bottle.
Clean the hose in the dishwasher (top rack only)
or let it soak in dish soap. The strange taste
usually goes away after the first bottle has been
consumed.
5