Dexter Laundry DCBD80 Series Instrukcja obsługi - Strona 15

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Suszarka Dexter Laundry DCBD80 Series. Dexter Laundry DCBD80 Series 17 stron.

Put the dryer in PROGRAM mode as instructed on page 13. The dryer remains in the PROGRAM mode until one of

these actions occur:

• The Program Button is actuated again.

• The eighteenth step is completed and the "Start"

• Programming is stopped for about a minute.

• The loading door is closed.

Observe the displayed value in each step. If no change is required, press "Start"

next program step. If a change is required, the values are made larger by the HIGH

button. The hour meter and the money audit can be reset to zero if the LOW

Note that after any reset or program change, it is necessary to advance to the next step by pressing "Start"

button to enter the revision. OTHERWISE, THE VALUE WILL REMAIN AS IT WAS BEFORE THE ALTERATION.

The following two features are available in the dryer. Disconnect power from the machine for two minutes

before modifying the machine for either option.

The dryer is shipped with this feature defeated. As shipped, when the machine stops at the end of the cycle,

the load will sit motionless in the machine until the user removes the load. The feature is activated by removing

the small jumper indicated in the figure of the PROGRAMMING INSTRUCTIONS. When the feature is activated, it

comes into operation at the end of every cycle if the door is not opened within five minutes after the cycle

finishes. At the end of this five-minute period, the machine will turn on and run for 10 seconds to redistribute the

load. This will occur after each 5-minute interval that goes by without the door ever having been opened for up

to 16 times. The opening of the door any time during this period will prevent any further occurrences for the

particular cycle.

There is a jumper on the control for this feature as shown in the figure of the PROGRAMMING INSTRUCTIONS.

As shipped, from the factory, with the jumper in place, this feature is defeated. This means that at the beginning

of each new cycle, the temperature will default to LOW

If the jumper is removed from the control, the operation is changed, so that when starting a new cycle, the

temperature remains at the last temperature selection used in the previous cycle. This would mean if the

previous customer has used a HIGH

would receive a HIGH

CHANGING PROGRAM DATA

AVAILABLE OPTIONS

Anti-Wrinkle Option

Last Temperature Used Option

selection and the next customer didn't select anything different, they also

cycle.

button is pushed following the eighteenth step.

if another temperature isn't selected by the customer.

- -

button to advance to the

button, smaller by the MED

button is pressed.