Aqua Creek PRO SPA 60 Podręcznik - Strona 12

Przeglądaj online lub pobierz pdf Podręcznik dla Systemy podnoszenia Aqua Creek PRO SPA 60. Aqua Creek PRO SPA 60 17 stron.

If the battery is fully charged and the lift is not moving then:

Check all cords:

A. Check that the cords are properly plugged in. Start by unplugging the remote and the actuator

cord from the control box. Once these cords are removed check the ends for corrosion or

damage. Plug the remote cord back in by lining up the raised tab on the plug to the grooved line

on the control box outlet. Note that these cords require some force to plug them in fully. You

will know they a correctly inserted when you here a "popping sound". The cords will be recessed

into the outlet. If they are flush with the outside of the outlet they are not plugged in fully and the

lift will not function. Make sure you do this for both cords.

NOT inserted fully.

If you have checked all the cords and the lift still doesn't move:

Check the contact points:

A. After you have fully charged the battery and checked the cords to make sure they are properly

plugged in, check to make sure the contact points are not corroded or bent. If the contact points

are corroded take some rubbing alcohol and a q-tip and clean off the points. After cleaning the

contact points it is recommended to put some dielectric grease on the contact points (terminals) to

help ensure good electrical contact and prevent corrosion. Then reinstall the battery on top of the

control box. Make sure you hear a "click", which indicates that the battery is correctly seated.

The lift will not work if the battery is not seated correctly.

Silver tabs are the contact

(terminal) points.

Fully inserted.