Aqua Creek PRO SPA 60 Podręcznik - Strona 6

Przeglądaj online lub pobierz pdf Podręcznik dla Systemy podnoszenia Aqua Creek PRO SPA 60. Aqua Creek PRO SPA 60 17 stron.

ADJUSTING SEAT ANGLE:

The angle of the seat arm is adjustable to provide

additional clearance from the spa wall. Adjust the

angle of the seat arm assembly by loosening the 3/8"

jam nut and adjusting the 3/8" bolt at the base of the

lifting plates (top of lifting arm). As shown in the

diagram to the right, tighten the bolt to increase

clearance, and loosen it to decrease the angle of the

seat arm. When the desired angle is achieved tighten

the jam nut to lock the angle.

OPERATING INSTRUCTIONS: PRO SPA

NOTE: CHECK ALL NUTS & BOLTS FOR TIGHTNESS BEFORE EACH USE

NOTE: CHECK DRIVE BELT FREQUENTLY TO PREVENT SLIPPAGE AND

PROLONG SYSTEM LIFE. (SEE BELOW "BELT TIGHTENING")

Before attempting to transfer into the chair, check the battery warning light on the 24v battery. If

this light is illuminated, this means the battery is at a low charge.

DO NOT attempt to use the lift if the "low charge" indicator light is on. Remove the battery

from the lift and place it on the wall mount charger until the battery is fully charged before

resuming use of the lift.

If your lift is equipped with a pullout leg-rest it will be necessary to

have the leg-rest engaged in the extended position with the leg-rest

flipped up for pool/spa walls higher than 36". For pool/spa walls

shorter than 36", the leg-rest may be flipped up or down.

You may transfer to the chair from either side, by flipping up the

armrest on the preferred side to allow for easy lateral transfer. Once

you are in the chair, lower the flip-up arm back into its normal

position for operating the lift. If your lift is equipped with a leg-rest,

position your legs comfortably on the leg-rest. Secure the adjustable

lap belt around your waist so that the belt is snug, but not

uncomfortably tight.

You are now seated comfortably in the lift, and ready to move into the pool or spa. Before you

begin the lift's operating cycle, take a visual check of the deck area and pool/spa area to ensure a

clear operating path.