Aqua Creek Scout 2 Podręcznik użytkownika - Strona 6
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Systemy podnoszenia Aqua Creek Scout 2. Aqua Creek Scout 2 17 stron. Pool lift
Drukuj stronęSaw-cut Retro-fi t/New construction
Mask the bottom hole of the anchor sleeve to prevent concrete from seeping in.
1.
Install rebar in the 3'-9" x 3'-9" section of the deck that will be thickened to 10". SEE
2.
FIGURES B & C.
Set the bronze anchor sleeve in place. Make sure the center of the anchor sleeve is
3.
no more than 35" from the pool's edge. Set the fi xing anchor insert 7 1/2" from the cen-
ter of the anchor sleeve. Fixing anchor may be located anywhere on the deck, as long
as it is 7 1/2" from the center of the anchor sleeve. SEE FIGURE B.
4.
Bond the anchor sleeve according to your local code requirements by using the
bonding lug and bonding screw on the side of the anchor sleeve.
5.
Pour your concrete and fi nish the pool deck surface.
Once the concrete has cured, your lift is ready to be mounted into the anchor sleeve.
6.
(MIN.)
22 1/2"
7 1/2"
3'-9"
(MIN.)
22 1/2"
2.19" O.D. X 6"
1-1/2" MIN
BRONZE ANCHOR
(FIXING-ANCHOR)
ASSEMBLY
3'-9" SQ. X 10" DEEP CONC. FTG.
W/ 4-#5 E.W., TOP & BTTM. (2500 PSI)
10"
4"
6"
1" x 4" PVC "FIXING-ANCHOR"
BONDING LUG:BOND PER LOCAL CODE
2.19
O.D. X 6" BRONZE ANCHOR ASSEMBLY
8-AWG SOLID COPPER WIRE (TO BONDING GRID)
DRILLING AND EPOXYING REBAR TO EXISTING SLAB
(4" MIN. EMBED W/ HILTI RE500 SD OR SIMPSON SET-XP EPOXY)
IS RECOMMENDED TO RESIST DIFFERENTIAL MOVEMENTS
FIGURE B
6
Copyright © 2018 Aqua Creek Products All Rights Reserved
Anchor Installation:
3'-9"
12"
MIN
7" MIN
(24" MAX)
19" MIN
(35" MAX)
POOL
WALL
2"
7 1/2"
CLR
3"
CLR
FIGURE C
Revised 6/8/18