Aqua Creek Scout 2 Podręcznik użytkownika - Strona 9

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Systemy podnoszenia Aqua Creek Scout 2. Aqua Creek Scout 2 17 stron. Pool lift

Scout 2 Assembly Instructions (cont.)

The CHAIR ASSEMBLY will arrive attached to the CHAIR ARM adjusted to its highest position.

To adjust the CHAIR ASSEMBLY to a lower position remove the hardware as shown in FIGURE G.

Slide the SEAT ASSEMBLY to its desired position (in 4" increments) and reinstall the hardware. The

maximum adjustment is 16".

DO NOT ATTACH THE CHAIR ASSEMBLY ANY LOWER THAN THE BOTTOM TWO HOLES – ALWAYS USE

THE TWO (2) SUPPLIED HEX BOLTS TO ATTACH THE CHAIR ASSEMBLY TO THE CHAIR ARM!

NOTE: For most applications the seat will be installed in its lowest position. For applications where a

wall or curb must be cleared the seat should be installed in a higher position. In its highest position,

the seat will clear a 11" [279mm] high wall with a footrest and a 26" [660mm] high wall with a legrest.

With the lift fully assembled and anchored, run the lift completely out and back in 3-5 times,

without weight, for the lifts "break in" cycle period.

CHAIR ARM

ADJUSTMENT

HOLES IN 4"

INCREMENTS

(16" ADJ. RANGE)

CHAIR ADJUSTED

TO LOWEST

POSITION

3/8" X 2-1/2"

3/8" FLAT

HEX BOLT

WASHER

5/16" X 3-1/2"

HEX BOLT

5/16" FLAT

WASHER

3/8" FLAT

WASHER

3/8" NYLOCK

NUT

5/16" NYLOCK

NUT

5/16" FLAT

WASHER

FIGURE G

Revised 6/8/18