AVM OVATION A 6.2 Instrukcja obsługi - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wzmacniacz AVM OVATION A 6.2. AVM OVATION A 6.2 14 stron.

1.5 Connection to mains

Connect the unit to the mains outlet (22) by using the power cord which is (in some countries)

delivered together with the unit. Make sure that mains voltage is according to the value

printed on the rear panel of the amp (near mains connector).

CAUTION: Keep the unit switched off until all audio connections are made.

You can connect up to seven analog line sources to your OVATION A 6.2. Connect the

outputs of your sigbal sources to the inputs of the A 6.2 on the rear side of the unit (14-17).

The upper row of the RCA/Cinch (16) or XLR (14) connectors is for left channels (white), the

lower row is for right channels (15, 17).

The A 6.2 has two switcheable speaker outlets. Connect one pair of the speakers to the

speaker terminals right (13), the other one to the terminals left (24). Use only good speaker

cables with sufficient diameter. Make sure that the red terminals are connected to the red or

"+" terminals of the speakers and the black terminals to the black or "–" terminals of the

speakers.

The outputs can be activated or deactivated via the menu (see 3.1.7).

1.8.1

Trigger outputs

Connect the trigger outputs (12) to the trigger inputs of the power amplifier or (if connected)

the subwoofer.Then these units will automatically switch on and off together with your A 6.2.

The pinning of the trigger outputs is described in section 1.3.3

1.8.2 Remote control of power amplifiers via audio cable

If you happen to use a model of the AVM PA oder SD series as a pre-amplifier, your A 6.2 can

be automatically switched on and off via a connected audio cable. There is no need for an

additional trigger cable.

Plug a 6.35 mm headphone connector to the headphone jack (7). The loudspeaker (13,24)

and preamp outputs (18-21) will mute automatically while a headphone is plugged in.