Aqua Creek Products Revolution F-702RLNA-SPA-04 Podręcznik - Strona 8

Przeglądaj online lub pobierz pdf Podręcznik dla Pomoc w poruszaniu się Aqua Creek Products Revolution F-702RLNA-SPA-04. Aqua Creek Products Revolution F-702RLNA-SPA-04 14 stron. Spa lift

Drukuj stronę

CONTROL ARM

LIFTING ARM

3/8" NYLOCK

NUT (2)

STEP 5: ADJUST THE SEAT POSITION

The SEAT ASSEMBLY will arrive attached to the SEAT ARM

adjusted to its highest position. To adjust the SEAT ASSEMBLY

to a lower position remove the hardware as shown below.

Slide the SEAT ASSEMBLY to its desired position (in 4 inch

increments) and reinstall the hardware. The maximum

adjustment is 16 inch (down).

DO NOT ATTACH THE SEAT ASSEMBLY ANY LOWER THAN THIS

– ALWAYS USE THE TWO (2) SUPPLIED BOLTS TO ATTACH THE

SEAT ASSEMBLY TO THE CHAIR ARM!

3/8" X 2"

SHOULDER BOLT

5/16" X 4 1/2"

HEX BOLT

Revolution Spa Assembly Instructions

STEP 4

3/8" FLAT

WASHER (2)

SEAT ARM

STEP 4: INSTALL SEAT ARM

Locate the SEAT ARM and the following hardware:

• (2) 1/2" x 3" SHOULDER BOLT

• (2) 3/8" FLAT WASHER

• (2) 3/8" NYLOCK NUT

Install the SEAT ARM at the ends of the CONTROL

1/2" X 3"

ARM and LIFTING ARM as shown in the ﬁ gure to the

SHOULDER

left. Tighten the NYLOCK NUTS until snug as shown in

BOLT (2)

PHOTO 4. DO NOT OVERTIGHTEN!

(NOTE: MAKE SURE THE SEAT IS FACING AWAY FROM

THE MAIN ASSEMBLY)

SEAT ARM

SEAT ASSEMBLY

ADJUSTED TO

LOWEST POSITION

STEP 5

5/16" FLAT

WASHER (3)

5/16" NYLOCK

NUT (2)

Revised 6/25/20

HOLES AT 4"

INTERVALS

ALLOW FOR

ADJUSTMENT

OVER 16"

RANGE

MAIN ASSEMBLY