AVM OVATION SA 6.3 Instrukcja obsługi - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wzmacniacz AVM OVATION SA 6.3. AVM OVATION SA 6.3 12 stron.

1.6 Connecting trigger inputs

If you use a pre-amplifier that is equipped with trigger outputs, connect them to the trigger input of

your MA / SA 6.3 (10) which will automatically switch on and off together with your pre-amplifier. The

pinning of the trigger outputs is described in section 1.2.3.

If you happen to use an AVM model of the PA or SD series as a pre-amplifier, your MA / SA 6.3 can

automatically be switched on and off via a connected audio cable – without the need for an additional

trigger cable. In addition, the display brightness can also be remote controlled (see section 2.3.3)

1.7 Connecting loudspeakers

Connect the "right" marked clips of the speaker terminal(s) to the right speaker, the "left" marked clips

to the left speaker (6). We recommend to only use loudspeaker cables of good quality and with

sufficient diameter to connect your loudspeaker to the output clips. Take care of the correct polarity

when connecting. The red marked output clips must be connected to the red loudspeaker clip or

marked with a plus sign. Right and left channels must be the same polarity.

The SA 6.3 is equipped with two switchable speaker outlets (6, 14) which are internally connected in

parallel. Hence, your loudspeakers may also be operated in bi-wiring mode.

NOTE: If you are using banana plugs, secure the outer parts of the sockets (by clockwise turning)

before inserting the pin. This will prevent unwanted rattling noises. On delivery, you may find some

plastic plugs covering the 4mm holes of the loudspeaker clips. These can be removed with a thin

screwdriver.

To be able to fully appreciate the tonal qualities of your MA / SA 6.3 amplifier, we recommend to keep

the speaker cables as short as possible. This way, extremely short paths between the power amplifier

and the loudspeaker, for the transport of electrical power, is achieved. We recommends to only use

cables of identical length for the right and the left channel.

1.8 Packing advice

The bottom of the flight case in which the unit is delivered is not symmetrical. If you want to pack the

unit into the case at a later point in time, please make sure to position the unit correctly.

2 Basic operation and advanced settings menu

2.1 Operating mode / Standby mode

Using the power button (1) you can switch between the operating mode and the standby mode. When

switched on, the display (4) lights up and the control LED (2) is switched off. In standby mode, the

display is switched off and the control LED is on to indicate the unit is still connected to the mains.

CAUTION: When switched to standby, the unit is still connected to the mains. In case of a

thunderstorm or if you leave the house for a longer time, we recommend you switch off the amplifier

by using the mains switch (13) or pull the mains plug (12).