AVM PA 30.3 Instrukcja obsługi - Strona 14

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wzmacniacz AVM PA 30.3. AVM PA 30.3 20 stron.

Now select the PA 30.3 ("AVM-30.3") as the device for audio playback and wait a short moment

until the connection is established. The display CONNECTED on the lower left side of the

display (6) indicates a successful connection of both devices. In this state the device is locked

for further playback devices so that the already started music playback cannot be interrupted

by another Bluetooth playback device. To start music playback from another Bluetooth device,

the Bluetooth connection to the PA 30.3 must first be interrupted on the current device. The

message ON AIR appears again in the lower left corner of the display. You can then pair your

PA 30.3 with another device.

NOTE: If the Bluetooth input is not selected, the integrated Bluetooth module is disconnected

from the power supply. The antenna does not emit any signal in this state. This prevents

possible interference. As soon as the Bluetooth input is selected again, your amplifier

automatically reconnects to the last connected Bluetooth device.

2.5 Volume settings

Use the VOLUME rotary control (9) to adjust the volume. The currently selected volume value

is shown on the right side of the display (6) with a numerical value from 0 to 99.5. If FIX is

displayed at this point, the AV Pass Through function is activated for the selected input and

the volume control is disabled. For details on the AV Pass Through function, refer to section

1.11 AV Pass Through (Home Theater Loop).

Often the signal sources present in a hi-fi system have different levels. When switching between

them, this results in a volume jump, which can be prevented by individually adjusting the input

sensitivity of the inputs. Select a local digital or analog input or BLUETOOTH with the source

selector (3) and adjust the monitoring volume to a comfortable level with the volume control (9).

Check by switching to other inputs whether the levels are nearly identical. If there is a

difference, press and hold the LEVEL button (7). By turning the volume control (9) you can now

adjust the level of the selected input in a range of -9.5 to +10.0 dB. After releasing the LEVEL

button (7), the sensitivity value for the selected input will be stored and the unit will return to its

normal operating state. Repeat this procedure until all levels are approximately identical.

NOTE: During level adjustment, all remote controls are disabled. While you are making menu

settings on the main unit, the supplied RC 3 remote control cannot be used.

By pressing and holding the balance button BAL (8) the right-left balance of the output signal

can be adjusted globally for all input channels by means of the volume control (9). The current

setting is shown in the display (6) on the right side while the BAL button is pressed. As soon

as you release the button, the set value is stored and the unit returns to its normal operating

state.