Dexter Laundry OPL Stack Express Broszura właściciela - Strona 10
Przeglądaj online lub pobierz pdf Broszura właściciela dla Pralka/suszarka Dexter Laundry OPL Stack Express. Dexter Laundry OPL Stack Express 17 stron. 30 lb (13kg) capacity computer control opl washer
Drukuj stronę
Ct **
Tumble Time
t
**
Water Temperature
L **
Water Level
dF *
Type of Fill
S **
Spin Time
IS *
Injection Source
1
A delayed fill will pause the time count until the selected level is reached. A timed fill will
only fill for a predetermined amount of time.
2
Codes for injections sources are defined at the end of the programming section. When the No
Water bath is selected, the electronic controller prohibits injection signals. The programmed
injection source value is ignored.
To exit the programming of a bath, press the "STOP" button once and use the "UP" and "DOWN"
keys select another bath. Press the "STOP" button again to select a different cycle to change. To
end programming, turn the key to "RUN" position
Note: The Wash Cycle programming mode will automatically exit and return to
the Idle mode if no buttons are pushed for one minute.
WASHER CYCLE PARAMETER RANGES
The range of each cycle parameter is shown below:
Cycle Time
Water Temperature
Water Level
Delay Fill
Spin Time
Injection Source
Two-digit amount of time in minutes.
HH for hot, CH for warm, CC for cold
and EE for no water.
Lo for low, Hl for high.
d for delayed fill, t for timed fill.
Two-digit amount of time in minutes.
Single digit code indicating injector signal(s).
0 to 15 minutes for Prewash, Wash, Rinse1, 2, 3 and 4
1 to 15 minutes for Final Rinse
For the bathes that can, if the time is set to zero, then the bath
will be eliminated from the cycle.
HH – hot, CH – warm, CC – cold, EE – no water
HI – high, LO – low
The selections are "d" for delay the bath time until water level
is reached or "t" for decrement bath time during the fill.
0 to 10 minutes for Prewash, Wash, Rinse, 2, 3 and 4
1 to 10 minutes for Final Spin
0 to 6
1
2