A.J.Antunes 9100533 Instrukcja obsługi - Strona 11
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Komercyjny sprzęt spożywczy A.J.Antunes 9100533. A.J.Antunes 9100533 16 stron. Steamer display cabinet
Drukuj stronę
To avoid possible personal injury and/or damage to the unit, the electrical equipment should be inspected, tested, and
repaired by qualified service personnel. The unit should be unplugged when servicing.
Problem
No heat, no display, and the
power switch indicator light is off.
No heat, no display, and the
power switch indicator light is on.
Display flashes "LO" and the
cabinet does not heat up.
Display flashes "HI" and the
cabinet does not heat up.
Display flashes "HI" and the
cabinet is very hot.
Display flashes "OPEN" and the
cabinet does not heat up.
Display flashes "PO" and the
cabinet does not heat up.
Display Cabinet glass is fogging
up and/or has condensation.
Halogen Bulb(s) do NOT light
up.
P/N 1010968 Rev. E 12/14
STEAMER DISPLAY CABINET SDC-500
TROUBLESHOOTING
Possible Cause
Power cord is not plugged in.
Circuit breaker is off or has been tripped.
No power at receptacle.
Inoperable power cord.
Inoperable power switch.
Loose, burnt, broken wiring in the circuit.
Inoperable Transformer.
Inoperable Control Board.
Loose, burnt, broken wiring in circuit.
Inoperable Solid State Relay.
Inoperable Control Board.
Inoperable Heater(s).
Loose, burnt, broken wiring in circuit.
Inoperable Thermistor.
Inoperable Control Board.
Solid State Relay contacts shorted closed.
Inoperable Control Board.
Thermistor is disconnected or open.
Inoperable Control Board.
For 120 volt units, the supply voltage is below
100 VAC or above 135 VAC.
Inoperable Control Board.
Water Tray(s) contain too much water and/or
the Water Tray Diffusers are not present (for
units equipped with Water Trays only).
Bulb(s) burnt out.
Inoperable Bulb Sockets(s).
WARNING
Plug the power cord into the appropriate outlet.
Reset circuit breaker, contact your maintenance person or
Authorized Service Agency if it trips again.
Contact your maintenance person or Authorized Service
Agency for service.
Contact your maintenance person or Authorized Service
Agency for service.
Contact your maintenance person or Authorized Service
Agency for service.
Contact your maintenance person or Authorized Service
Agency for service.
Contact your maintenance person or Authorized Service
Agency for service.
Re-secure the Thermistor onto the Control Board. If
problem persists, contact your maintenance person or
Authorized Service Agency for service.
Contact your maintenance person or Authorized Service
Agency for service.
Remove excess water from the Water Tray(s) and/or install
the Water Tray Diffuser(s).
Replace bulb(s)
Contact your maintenance person or Authorized Service
Agency for service.
11
Corrective Action