Aqua Guard MP425 Instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Filtr basenowy Aqua Guard MP425. Aqua Guard MP425 12 stron. Pool cartridge filter

Installation

Equipment Inspection

NOTE: This filter should only be installed by qualified

personnel.

Carefully inspect equipment before installing. Occasionally,

products are damaged in transit. Any damaged filter

components can cause failure and should be replaced

immediately.

aquaguardpoolsystems.com

TYPICAL HEAD LOSS

Flow (GPM)

Outlet

Inlet

100

1. The filter system should be installed on a level concrete

slab or other rigid base. Select a well drained and vented

area, one that does not flood when it rains. Position the

filter so that the piping connections, and winter drain

are convenient and accessible for operation, service,

maintenance and winterizing.

2. Position filter body such that all operation and safety

labels are visible.

3. Position filter so the filter will drain by gravity.

4. If practical, place pump and filter in the shade to shield it

from continuous, direct heat from the sun.

5. Connect the pool suction plumbing between the

skimmer, pool suction outlet (from the pool) and the

pump.

6. Connect the pump discharge (pump OUTLET) to the filter

INLET.

7. Connect the bottom filter port (filter OUTLET) to the pool

return plumbing lines.

8. Do not locate pump controls over or near filter.

9. Verify water discharge from the manual air relief valve

(MAR) is directed away from electrical devices.

120

140

160