Avocent SWITCHVIEW PC Instrukcja szybkiej instalacji
Przeglądaj online lub pobierz pdf Instrukcja szybkiej instalacji dla Przełącznik Avocent SWITCHVIEW PC. Avocent SWITCHVIEW PC 2 stron. 2 or 4-port ps/2 desktop kvm switch
Również dla Avocent SWITCHVIEW PC: Broszura i specyfikacje (8 strony), Instrukcja szybkiej instalacji (12 strony), Instrukcja szybkiej instalacji (4 strony)
Drukuj stronę
The following instructions will help you
connect your SwitchView unit.
Should you require further assistance, please
contact Avocent Technical Support.
NOTE: All drivers necessary for the SwitchView
are built into the unit. If you are installing the unit
with a Windows operating system and are
prompted for drivers, press NEXT until the
configuration is complete.
NOTE: If keyboard or mouse issues arise when
using a low-power system such as a laptop, you
should order an optional power supply by
contacting Avocent Technical Support.
1
(Optional) Powering the
SwitchView unit
Power down all computers that will be attached to your
SwitchView unit. If necessary, plug one end of the power
supply (sold separately) into the power socket on the
rear of the SwitchView unit. Plug the other end into an
appropriate AC power source.
2
Connecting the peripheral devices
Plug your VGA monitor into the port labeled CONSOLE
on the back of the SwitchView. Plug your keyboard and
mouse into the labeled ports on the front of the unit.
3
Connecting the first computer
Locate an Avocent SVPS2C-6A or SVPS2C-9A cable
(sold separately). Attach one end to the corresponding
Avocent, the Avocent logo, The Power of Being There and SwitchView are trademarks or registered trademarks of Avocent Corporation or its affiliates. All other marks are the property of their respective owners. ©2003 Avocent Corporation. All rights reserved.
Quick Installation Guide
SwitchView PC
To connect a SwitchView PC
2
Plug in the monitor,
followed by
the keyboard
and mouse.
DC 12V, 1A
C
1
(Optional) Power
down your
computers and attach
the appropriate
power supply.
connectors on the first computer to be attached to the
SwitchView. Route the other end of the cable to the
SwitchView and attach the remaining connectors to
an available port set. The port sets are labeled to
correspond with the channels on the unit.
4
Connecting the remaining computers
Repeat step 3 to connect additional computers.
PC4
PC3
CONSOLE
3
Connect the first
computer to the
SwitchView unit.
5
Powering attached computers
Next to each port is a blue LED. A blinking LED indicates
that the attached computer is not powered.
Power the first attached computer. Wait until it has
completely booted before switching to the next
computer and repeating the process.
The Power of Being There
5
Power up all
attached
PC2
PC1
computers.
4
Plug in the remaining
computers to the
SwitchView unit.
590-367-113B