COZY VC352A and Instrukcja instalacji i obsługi - Strona 10
Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Grzałka gazowa COZY VC352A and. COZY VC352A and 18 stron. Gas-fired vented room heater
Również dla COZY VC352A and: Instrukcja instalacji i obsługi (17 strony)
Drukuj stronę
MODELS:
VC201A, VC202A, VC351A, VC352A, VC501A, VC502A, VC701A,
VC702A,
VCR351A,
VCR352A,
VCR501A,
VCR502A,
VCR701A,
VCR702A
FOR YOUR SAFETY
READ
BEFORE
LIGHTING
I WARNING: If you do not follow these instructions exactly, a fire or explosion may result
causing property damage, personal injury or loss of life.
A.
This appliance has a pilot which must be lighted by hand.
When
lighting
the pilot, follow
these instructions
ex-
actly.
B.
BEFORE
LIGHTING
smell all axouM the appliance area
tbr gas. Be sure to smell next to the floor because
some
gas is heavier
than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS:
Do not try to light any appliance.
Do not touch any electric
switch; do not use any phone
in your building.
Ilnmediately
call your gas supplier
from a neighbor's
phone.
Follow the gas supplier's
instructions.
I
If you cannot reach your gas supplier, call the fire department.
C.
Use only your hand to push in or mm the gas control knob.
Never use tools. If the knob will not push in or turn by
hand, don't try to repair it, call a qualified service technician.
Force or attempted repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under water.
hnmediately
call a qualified service technician to inspect
the appliance and to replace any part of the control system
and any gas control which has been under water.
LIGHTING
INSTRUCTIONS
1.
2.
STOP! Read the intbnnation on the safety label.
Turn temperature control knob to "OFF" or it's
lowest position.
Depress and turn gas control knob clockwise
/"X to "OFF" position.
Pilot is located on
end of combustion
chamber above
burner.
5.
6.
7.
8.
Gas Control Knob
NOTE: Knob can
not be turned fioln
"PILOT" to "OFF"
unless knob is
pushed in slightly.
Do not force.
Wait five (5) minutes to clear out any gas. Then
smell for gas, including near the floor. If you smell
gas, STOP! Follow "B" in the inforlnation on the
safety label. If you don't smell gas, go to the next
step.
Open casing door and pilot lighting hole cover.
Findpilot. (Followmetalpitot robe fiom gas control).
Locate red piezo ignitor button on top of heater.
Turn gas control knob countercloclcvvise _
to
"PILOT".
10.
11.
12.
Push in gas control kmob and hold in. hnlnediately
begin a series of pushing and releasing the red
piezo iNlitor button, while observing the pilot.
Continue to spark until pilot is lit. Continue to
hold the gas control knob in for about one (1)
minute after the pilot is tit. Release the gas control
knob and it will pop back up. Pilot should remain
lit. If pilot goes out, repeat steps 3 thin 9.
If knob does not pop up when released, STOP
and immediately call your service technician
or gas supplier.
If the pilot will not stay lit after several tries,
turn the gas control knob to "OFF" and call
your service technician or gas supplier.
Close pilot lighting hole cover and casing
door.
Turn gas control knob counterctoclcvvise
to "ON".
Turn telnperature control knob to desired setting
1.
2.
TO TURN OFF GAS TO APPLIANCE
Turn the telnperature control knob to it's lowest setting.
Push in gas control knob slightly and turn clockwise
/'N to "OFF". Do not force.
Page 10