Aqua Lung apeks XTX 200(FSR) Instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Kontroler Aqua Lung apeks XTX 200(FSR). Aqua Lung apeks XTX 200(FSR) 20 stron.

Regulator Owner's Manual

............................................................................................

General Precautions & Warnings

•

B efore using this regulator, you must receive instruction and

certification in SCUBA diving from a recognised training agency.

Use of SCUBA equipment by uncertified or untrained persons is

dangerous and can result in injury or death.

•

T his regulator is not configured for commercial use with surface

supplied air.

•

A lways pressurise the regulator gradually by opening the cylinder

valve SLOWLY.

•

U nless instructed, NEVER apply any type of lubricant to any part

of the regulator or cylinder valve.

•

D O NOT apply any type of aerosol spray to the regulator. Doing

so may cause permanent damage to certain plastic components,

including the second stage housing.

•

F actory prescribed service for this regulator must be performed at

least once annually by a factory trained Apeks / Aqualung service

technician who is employed by an authorised dealer. Disassembly,

repair, or first stage adjustment must not be attempted by persons

who are not factory trained and authorised by Apeks / Aqualung.

•

D O NOT leave a cylinder standing unsecured with the regulator

attached to the valve. Doing so may cause permanent damage to

the regulator and cylinder valve if the cylinder falls over.

•

D O NOT carry SCUBA equipment by the first stage when it is

connected to a cylinder. Always carry the cylinder by the cylinder

valve or an attached carrying device.

•

W hen diving in cold water (below 10°C, or 50°F), you must have

received training and certification in the techniques of cold water

diving from a recognised training agency. Correct Selection

of specific cold water equipment is required. Any equipment

marked with the greater than 10º Celcius symbol; (> 10°C) are

only suitable for water temperatures above 10°C or 50°F.

• When configuring your regulator for use with emergency auxiliary

Breathing systems (Octopus), the correct selection of equipment is

required. Any equipment marked with EN250A is suitable for use

with an octopus.