DF-models Sky Watcher Podręcznik - Strona 14
Przeglądaj online lub pobierz pdf Podręcznik dla Quadcoptery DF-models Sky Watcher. DF-models Sky Watcher 19 stron.
Drukuj stronę
Trouble flying
WARNING!
1.The consumer must turn off the power of the drone after flight.
2.Because the drone does not have the function of automatic return at
low voltage, consumers should fly the drone back to the safe visual
range after the remote controller has a low voltage alarm. Drone
The consumer must turn off the power of the drone after flight.
battery low voltage and remote control power low voltage will lead the
remote control to alarm, consumers should immediately replace the
battery.
3.Consumers should pay more attention to the altitude of the drone when
flying, in order to avoid crashes caused by collision obstacles.
4.Geomagnetic correction for the drone, it is required (a must) when
consumer first buy/fly the drone or after changing the propellers/motors.
(Outdoor flying is to use the gps satellites for geomagnetic landmark
positioning. Positioning and auto return will be more accurate after a
new geomagnetic correction.)
5.When the power of the remote control or the drone is insufficient, the
remote control distance will be affected.
6.If the drone power is insufficient, it will be difficult to fly the drone or
even take off the drone.
7.If the drone is damaged or deformed, please repair it in time. If the
blade is broken or damaged, do not fly, otherwise it may cause injury.
8.Remove the battery from the remote control when it is not in use for a
long time. Avoid damage to this product caused by battery leakage.
9.Never allow the drone to crash or crash badly from high altitude, which
can damage the drone or shorten its service life.
10.In order to ensure the stability of the drone, when the drone hits the
object and suddenly drop, please put the drone on the horizontal ground
and stay for 2-3 seconds, after the automatic test level, then to try to fly
the drone again.
24
problem
possible cause
The indicator lights of the
1.Transmitter is not synced
drone are flashing and does
to the drone.
not respond to the transmitter.
2.Insufficient battery power.
1.Insufficient battery power.
The propellers spin,but
2.The propellers are installed
the drone cannot take-off.
in wrong orientation.
3.The propellers are distorted.
The drone sways sharply.
The propellers are distorted.
Drone cannot stay balanced
1.The propellers are distorted.
in flight.
2.The motor doesn't work
properly.
Six-axis acceleration sensor
The drone is out of control
losed its balance after
after crashing.
crashing.
The drone rotates upwards
The motor doesn't work
when pushing up the throttle
properly
lever or the drone sways
How to replace the motor
Warning: since this drone uses brush motors which has a finite life span,
the normal operation of the drone is able to fly 25 cycles. Therefore,
consumers should replace the motor immediately when they have
deviation during flight.
1. Loosen the lamp cover screw and remove the lamp cover.
solution
1.Refer to the preparation
for FLIGHT and pair again.
2.Recharge the battery.
1.Recharge the battery.
2.Install the propellers in
right orientation.
3.Replace the propellers.
Replace the propellers.
1.Replace the propellers.
2.Replace the motor.
Restart and re-calibrate
the drone.
Replace the motor
25