Aqua Lung PARA SWIMMER VEST Podręcznik użytkownika - Strona 2

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Sprzęt bezpieczeństwa Aqua Lung PARA SWIMMER VEST. Aqua Lung PARA SWIMMER VEST 2 stron.

Drukuj stronę

PRE-OP CHECK OUT

Prior to each use, the vest should be given a thorough visual inspection

and function test.

1. Fully inflate the vest and set aside for 30 minutes; loss of firmness indicates

leakage, which must be corrected before use.

2. Ensure that all stitched together components are not separating.

3. Check that the oral inflation tube and valve properly functions by depressing

the valve and blowing into the tube. Ensure the knurl nut on the oral inflation

tube turns freely.

4. Remove the CO

cartridges and inspect both actuators. Ensure both ac-

tuators operate correctly by pulling the knob to operate the actuating lever

and checking that the piercing pin travels up and down. Return the actuat-

ing lever to the firing position prior to re-threading the CO

the actuator.

NOTE:

Ensure the actuator is free of debris and the CO

washer is in place prior to re-installing the CO

5. Perform a function check on the over pres-

sure relief valve (OPRV) by fully inflating the

vest and then squeezing the vest to ensure

the OPRV opens allowing air to escape.

Next, pull the knob and cord assembly to

ensure the dump valve is correctly working

by allowing air to escape (See Fig. 3).

NOTE:

The over pressure relief valve (OPRV) will actuate when the

pressure inside the vest exceeds 1 - 2 PSI (0.07 - 0.24 BAR) greater

than external pressure.

FOLDING THE VEST

Prior to each use, the vest should be placed in its proper configuration.

1. Ensure vest is clean and dry. Lay flat and

deflate the vest.

2. Fold lower edge up until the bottom edge

of the bottle wrap is visible underneath.

(See Fig. 4).

cartridge into

cartridge

cartridge.

Figure 3

Figure 4

3. Fold each side in and overlap them until

cartridges are visible on each side.

(See Fig. 5).

4. Secure the bottle wrap around the vest by

laying the left flap over the right flap and

securing the hook and loop tape together

tightly (See Fig. 6).

NOTE:

Use of the optional HABD

pocket is possible only if the PSV is

not folded.

POST-OP MAINTENANCE

Proper maintenance will provide for years of reliable service. The Para

Swimmer Vest should be stored away from direct sunlight.

1. After each use, soak the exterior of the

vest with fresh water.

2. Detach HABD/SEA pocket (optional)

and fresh water rinse all components

(See Fig. 7).

3. Open storage pocket and fresh water rinse.

Ensure the hook and loop fabric is clean

from all debris (See Fig. 8).

4. Unscrew both CO

cartridges from the

actuators and fresh water rinse all

components.

NOTE:

Remove

cartridge

washer from actuator prior to fresh

water rinse.

Figure 5

Figure 6

Figure 7

Figure 8