Avocent Rack Mount Kit Instrukcja szybkiej instalacji
Przeglądaj online lub pobierz pdf Instrukcja szybkiej instalacji dla Stojaki i stojaki Avocent Rack Mount Kit. Avocent Rack Mount Kit 2 stron. For hmx extender system
Drukuj stronę
QUICK INSTALLATION GUIDE
For manual downloads, visit:
www.avocent.com/manuals
The following instructions will help you
install your rack mount kit.
Should you require further assistance,
please contact Avocent Technical Support.
RACK MOUNT SAFETY
CONSIDERATIONS
If mounting this product in an equipment
rack, the following considerations shall
apply for safe installation and use of this
product.
Elevated Ambient Temperature: If
installed in a closed rack assembly,
the operation temperature of the rack
environment may be greater than room
ambient. Use care not to exceed the
rated maximum operating temperature
for this product. The rated maximum
operating temperature is specified in the
technical specifications section in the
complete user's manual for this product.
Reduced Air Flow: Installation of the
equipment in a rack should be such
that the amount of airflow required for
safe operation of the equipment is not
compromised.
Mechanical Loading: Mounting of
the equipment in the rack should be
such that a hazardous condition is not
achieved due to uneven mechanical
loading.
Circuit Overloading: Consideration
should be given to the connection of
the equipment to the supply circuit and
the effect that overloading of circuits
might have on overcurrent protection
and supply wiring. Consider equipment
nameplate ratings for maximum current.
To Contact Avocent Technical Support: Visit www.avocent.com
Avocent and the Avocent logo are registered trademarks of Avocent Corporation or its affiliates in the U.S. and other countries. All other marks are the property of their respective owners. ©2010 Avocent Corporation.
HMX Extender System
2
HMX Transmitter
Reliable Earthing: Reliable earthing
of rack mounted equipment should be
maintained. Pay particular attention to
supply connections other than direct
connections to the branch circuit (for
example, use of power strips).
Overview
The HMX extender system rack mount
kit allows A/V professionals to mount
one or two HMX transmitters safely
and securely in the rack. For more
information on the HMX extender system,
refer to the HMX Extender System
Installer/User Guide.
Attaching the transmitter
1
For a single installation, attach the front
of the HMX transmitter to the back of
the rack mount shelf. The holes in the
front plate of the transmitter will snap
onto the pegs at the rear of the rack
Rack Mount Kit
Power
Supply
VELCRO
1
HMX Transmitter
3
Source Server
HMX Receiver
mount shelf. For a dual installation,
attach the second transmitter to the
other side of the rack mount shelf by
snapping it into place.
Securing the power supply
2
Attach the included VELCRO® strips to
the rack mount shelf and the bottom of
the transmitter's power supply. Attach
the power supply to the shelf.
Attaching cables to the
3
transmitter
Plug the power supply's DC connector
into the transmitter's power connection.
Attach the peripheral connector cable
to the transmitter and tighten the
screws firmly for a good connection.
Plug in the CAT 5 network cable. For a
dual installation, repeat these steps with
the second transmitter.
590-1025-501A