Avon AC1240IC Instrukcja obsługi i podręcznik informacyjny - Strona 2
Przeglądaj online lub pobierz pdf Instrukcja obsługi i podręcznik informacyjny dla Ładowarka Avon AC1240IC. Avon AC1240IC 5 stron. Electronic smart charger
Drukuj stronę
GENERAL INFORMATION
1. Retain these instructions for future use.
2. Store this product in a dry place to avoid moisture damage.
3. There are no user-serviceable parts in this product. Opening the case is dangerous and should therefore
only be carried out by qualified persons. Resultant damage to the product will result in the loss of your
guarantee.
4. Do not use this product if it is damaged in any way.
5. Only use this product for the purposes described in this instruction booklet. Failure to do so will result in the
loss of your warranty. The manufacturer will not accept liability for damage to the charger, persons or
property resulting from incorrect usage.
SAFETY
The use of safety goggles and gloves when working with lead acid batteries is strongly advised. Avoid contact
with the electrolyte as this is acidic and is likely to cause burns to the skin or clothes. If this occurs you should
rinse the affected area with plenty of water immediately. In the event of burns to the skin, medical advice
should be sought if the symptoms persist.
DISPOSAL
In the event that this product must be disposed of, an authorised place for the recycling of electrical and
electronic appliances must be sought.
Household Recycling Centres with applicable facilities.
This product must not be disposed of with general domestic waste.
RECOMMENDED USES
This product is suitable for charging 6V and 12V lead acid, sealed lead-acid, maintenance-free and AGM
batteries of capacities 1.2Ah to 120Ah (Ampere hours). Check with your device manufacturer if you are
unsure about the suitability of this charger for use with your device.
BATTERY CHARGING INSTRUCTIONS
Please read your vehicle manufacturer's instructions for further information and advice regarding the
disconnection of the battery for charging purposes.
IMPORTANT: This model will only recover 12V batteries with a minimum residual voltage of 7.5V, or 6V
batteries with a minimum residual voltage of 4V. If the residual voltage is lower than above figures, the
charger will not operate. NOTE : This charger operates automatically and will change operating status
without warning.
Maintain as much distance as is practical between the battery and charger. Monitor the temperature of the
battery during charging. If the temperature of the battery exceeds 40
cooled to a safe temperature. Failure to do so may result in the battery exploding.
Batteries store large amounts of energy. Avoid short circuits which could result in a dangerous electrical
discharge that could result in personal injury and / or damage to equipment and property. The charger will
automatically detect the voltage (6V or 12V) and diagnose the condition of your battery, the first stage of the
5 Step charging cycle (as listed in part 4).
1. PREPARATION OF THE BATTERY
In the case of lead-acid batteries, firstly remove the caps from each cell and check the level of liquid. If it is
below the recommended level, top up with ionized or distilled water.
UNDER NO CIRCUMSTANCES SHOULD TAP WATER BE USED
Contact your local authority for information concerning local
1
0
C cease charging until the battery has