Billet Specialties Tru Trac 13125 Instrukcja instalacji - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Silnik Billet Specialties Tru Trac 13125. Billet Specialties Tru Trac 13125 9 stron. Small block chevrolet
Drukuj stronę
Figure 12: Install Crank Pulley
Apply anti-seize to:
• (3) 3/8-24 x 1" Socket Head Cap Screws
Using three (3) 3/8-24 x 1" socket head cap
screws with 3/8" Belleville washers align and
install the crankshaft pulley. Cup on washer
should go towards pulley. Torque to 35ft.lbs.
Note: Some crate engines will have a large
center bolt and washer on the damper that
will need to be removed before the pulley
can be installed. This bolt should be replaced
and installed after the pulley with a
7/16-20 x 2-3/4" bolt.
Figure 13: Install Water Pump Pulley
Apply anti-seize to:
• (4) 5/16-24 x 1/2" Socket Head Cap Screws
Align and install the water pump pulley using
four 5/16-24 x 1/2" socket head cap screws.
Tighten firmly.
14
www.billetspecialties.com • Tech Line 708.588.0505
A
Figure 14: Install Tensioner Pulley
Apply anti-seize to:
• (1) 3/8-16 x 3/4" 12-point Cap Screw
A] Align the tensioner pulley onto the tensioner's mounting boss. Install the 3/8-16 x 3/4"
12-point cap screw with aluminum load washer as shown. Tighten firmly.
Figure 15: Install Serpentine Belt
With a 5/8" 6-point socket or wrench, turn the belt tensioner release nut clockwise to unload
the spring tension and install the serpentine belt (routing shown below). Slowly return the
tensioner to its starting position to apply tension to the belt.
With Power Steering
Small Block Chevrolet Tru Trac - 13225 / 13125
Without Power Steering
15