Aqua One AquaGrande 180 Instrukcja obsługi - Strona 11
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Akwaria Aqua One AquaGrande 180. Aqua One AquaGrande 180 17 stron.
Również dla Aqua One AquaGrande 180: Instrukcja montażu (4 strony)
Drukuj stronę
Filter Maintenance
WEEKLY
1. Turn the power head off.
2. Remove the lids from the filter unit.
3. Remove the elbow from the top of the power
head.
4. Remove the black sponges and carbon
cartridge from the filter unit.
5. Empty a small amount of water from the
aquarium into a bucket.
6. Rinse the black sponges in the bucket.
Discard the used water; do not add it back into
the aquarium.
7. Rinse the carbon cartridges out under the
tap, rinse thoroughly, or replace with new ones.
8. Re-insert the carbon cartridges and black
sponges.
9. Then connect the elbow back in to the top of
the power head. Make sure the holes of the
spray bar are pointing down onto the carbon
cartgridges and that the end of the spray bar
has the cap fitted.
10. Ensure the aquarium is full. Refer to Fig 21.
11. Turn the power head back on and ensure
that water is flowing out of the spray bar.
12. Replace the lids on the filter unit.
13. Add a filter supplement.
MONTHLY
See diagrams on next page...
1. Turn the power off. And unplug both power
leads.
2. Remove the light unit and place it some-
where safe away from water and where it will
not be broken / damaged.
3. Remove filter unit from aquarium and take to
sink and remove the lids.
4. Disconnect spray bar and elbow and clean
with double ended pipe brush.
5. Slide the power head off the bottom of the
filter unit. Fig 1
6. You will need a flat head screw driver. Fig 2
7. Holding the power head upside down Insert
the screw driver into the larger slot of the power
head. Fig 3
8. Carefully leaver the screw driver downwards.
9. This will pop one side of the impeller cap off.
Fig 4
10. Turn the power head around, repeat steps
7, 8 & 9. 11. Grasp the impeller cap and remove it
from the motor. Fig 5
12. Remove the impeller. (If it does not come out
when the Iimpeller cap is removed)
13. Use an Aqua One Double Ended Pipe Brush
(sold separately) to clean impeller and inside of
impeller chamber. Fig 6
14. Also run a pipe brush through the outlet at the
top of the power head.
15. Clean the intake pipe and strainer thoroughly.
16. Reconnect all parts and place filter unit back
onto the aquarium.
17. Ensure the power lead is not wet and plug it
back in.
18. Turn the power back "on" and check that
water is flowing though the spray bar.
19. Replace the light unit and lids on the filter unit.
YEARLY
The ceramic noodles are designed to be mainte-
nance free, NEVER RINSE THEM IN TAP
WATER.
See Hints & Tips for Best Results for more
information.
11