CP Plus CP-GR-DE413-S Instrukcja szybkiej instalacji - Strona 7
Przeglądaj online lub pobierz pdf Instrukcja szybkiej instalacji dla Router sieciowy CP Plus CP-GR-DE413-S. CP Plus CP-GR-DE413-S 8 stron. Dual-band 4g router
Drukuj stronęc. AP mode: The device accesses the Internet through the wired mode. The NAT function will be stopped. The
physical interface of the device WAN is converted into the LAN interface mode. The network is shared to the
wired and Wi-Fi users. The network service and information are provided by the upper device. Provides
services that convert wired to Wi-Fi.
Note –
If the device needs to be set to "Routing Mode" or "AP Mode", please refer to the above instructions and follow the
instructions of the operation guide. After the setup is complete, the device will restart, and the PC/Laptop searches
for a new Wi-Fi name signal to enter the password to access the Wi-Fi.
C. Frequently Asked Questions
Ques: After the 4G card is plugged in, the 4G light of the 4G routing body is not lit, which causes the Internet to be
unavailable?
Ans: Most of the cases are that the 4G card is not plugged in. The solution is to power off the 4G route and re-insert
the card. Because the card slot is deep, the nail is short, and the card is inserted with the toothpick. Another situation
is the 4G card is not activated and must be activated after use according to the card instructions.
Ques: 4G router works normally, the body 4G light is on, and the PC/Laptop is connected to 4G routing Wi-Fi but
cannot access the Internet?
Ans:
1. Enter the routing setting page (the default is 192.168.0.1, the username and password are both admin),
check the status---whether the WAN port obtains the IP address. If it is not obtained, it is recommended to
reset the 4G route reset.
2. Identify the Internet through the APN setting, insert the 4G card into the mobile phone, view the APN
Static IP Mode