AVP On The Road AVP-ND-100 Instrukcja instalacji - Strona 5
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Akcesoria samochodowe AVP On The Road AVP-ND-100. AVP On The Road AVP-ND-100 5 stron. Sequential led turn signal light
Drukuj stronę
Fully insert the board inside the unit, and at the end, twist the connector counterclockwise a bit and
press down to get it fully inserted. Lock the connector by rotating it clockwise.
Step 7
Insert the rubber grommet back into position, by pushing with two fingers.
Insert the light unit back and install the connector.
Remark: If the car is a European spec car clip the included ballast resistors in between the lights
connector and the factory connector
Test installation by turning on Hazard mode.
Repeat the installation steps for the passenger side.