Aqua Power AQM 2-1 Obsługa i instalacja - Strona 8

Przeglądaj online lub pobierz pdf Obsługa i instalacja dla Podgrzewacz wody Aqua Power AQM 2-1. Aqua Power AQM 2-1 12 stron. Tankless electric water heater

Drukuj stronę

INSTALLATION

INITIAL START-uP

» 7. The AQM is designed for connection to a braided

stainless steel hose with a 3/8" OD Tube Outlet.

» 8. When all plumbing work is completed, check for leaks

and take corrective action before proceeding.

7.3

Electrical connection

WARNING: BEFORE BEGINNING ANY WORK ON THE

ELECTRIC INSTALLATION, BE SURE THAT THE MAIN

CIRCUIT BREAKER PANEL SWITCH IS "OFF" TO AVOID ANY

DANGER OF ELECTRIC SHOCK. FAILURE TO DO SO MAY

RESULT IN SERIOUS INJURY OR DEATH. ALL MOUNTING AND

PLUMBING MUST BE COMPLETED BEFORE PROCEEDING

WITH ELEC TRICAL HOOK-UP. WHERE REQUIRED BY

LOCAL, STATE OR NATIONAL ELECTRICAL CODES, THE

CIRCUIT SHOULD BE EQUIPPED WITH A GROUND FAULT

INTERRUPTER.

WARNING: AS WITH ANY ELECTRIC APPLIANCE, FAILURE

TO ELECTRICALLY GROUND UNIT MAY RESULT IN

SERIOUS INJURY OR DEATH.

CAUTION: INSTALLING AN AQM 2-1, AQM 2.5-1, AQM 3-1,

OR AQM 3.5-1 ON A 208 V OR 220–240 V CIRCUIT WILL

DESTROY THE HEATING ELEMENT. THIS IS CONSIDERED

IMPROPER INSTALLATION AND WILL VOID YOUR

FACTORY WARRANTY.

Voltage

AQM 2-1:

110–120 V

AQM 2.5-1:

110–120 V

AQM 3-1:

110–120 V

AQM 3.5-1:

110–120 V

AQM 4-2:

220–240 V, 208 V

AQM 6-2:

220–240 V, 208 V

1. All electrical work must comply with national and applicable

state and local electrical codes.

2. The AQM should be connected to a properly grounded

dedicated branch circuit of proper voltage rating. In installa-

tions with several AQM units, each unit requires an independent

circuit. Please refer to the technical data table for the correct wire

and circuit breaker size.

3. Reinstall plastic cover.

| AQM TANKLESS ELECTRIC WATER HEATERS

press

Initial start-up

WARNING: OPEN HOT WATER FAUCET FOR A FEW

MINUTES UNTIL WATER FLOW IS CONTINUOUS AND

ALL AIR IS PURGED FROM WATER PIPES. THE UNIT'S PLASTIC

COVER MUST BE INSTALLED BEFORE THE CIRCUIT BREAKER

IS TURNED ON.

electroni

Water heater hand over

press

Explain the functions of the unit to the user and familiarize him

or her with its use.

Important instructions:

°C

» Draw the user's attention to possible hazards (scalding).

» Hand over these instructions for future reference.

» In order to obtain a proper temperature at a single spout

electronic

mixer-type faucet, restrict cold water flow to faucet by

partially closing the cold water shut-off valve under the sink

until cold water and hot water flow rates are approximately

the same.

10. Normal maintenance

CAUTION: OTHER THAN THE FILTER SCREEN, THE

AQM DOES NOT CONTAIN ANY PARTS SERVICEABLE

BY THE LAY PERSON. IN CASE OF MALFUNCTION PLEASE

CONTACT A LICENSED PLUMBER OR ELECTRICIAN.

AquaPower AQM tankless heaters are designed for a very long

electroni

service life. Actual life expectancy will vary with water quality

and use. The unit itself does not require any regular maintenance.

However, to ensure consistent water flow, it is recommended

to periodically remove scale and dirt that may build up at the

aerator of the faucet or in the shower head. Also, the AQM has

a built in filter screen that should be cleaned from time to time.

In order to do this, turn off the cold water supply at the isolating

valve. Clean screen and put the screen back into its original

position.

°C

WWW.APTANKLESS.COM

°C