CPA CPA-0010-01009D01 Instrukcja obsługi i instalacji - Strona 5
Przeglądaj online lub pobierz pdf Instrukcja obsługi i instalacji dla UPS CPA CPA-0010-01009D01. CPA CPA-0010-01009D01 7 stron. Standby ups
Drukuj stronęCPA-0010-01009D01
User's Manual
SAFETY PRECAUTIONS
•
This UPS utilizes voltages that may be hazardous. Do not attempt to disassemble the unit. The unit
contains no user replaceable parts. Only factory service personnel may perform repairs.
•
This pluggable type A equipment with battery already installed by the supplier is operator installable
and may be operated by laymen.
•
The mains socket outlet that supplies the UPS shall be installed near the UPS and shall be easily
accessible.
•
During the installation of this equipment, it should be assured that the sum of the leakage currents of
the UPS and the connected loads does not exceed 3.5mA.
•
Connection to any other type of receptacle other than a two-pole, three-wire grounded receptacle may
result in shock hazard as well as violate local electrical codes.
•
In the event of an emergency, press the "OFF" button and disconnect the power cord from the AC power
supply to properly disable the UPS.
•
Do not allow any liquids or any foreign object to enter th e UPS. Do not place beverages or any other
liquid-containing vessels on or near the unit.
•
This unit i s intended for installation in a controlled environment (temperature controlled, indoor
area free of conductive contaminants). Avoid installing the UPS in locations where there is standing or
running water, or excessive humidity.
•
Do not plug the UPS input into its own output.
•
Do not attach a power strip or surge suppressor to the UPS.
•
A battery can present a risk of electrical shock and high short circuit current. The following precautions
should be observed when working on batteries:
1) Remove watches, rings, or other metal objects from the hands.
2) Use tools with insulated handles.
3) Wear rubber gloves and boots.
4)
Do not lay tools or metal parts on top of batteries.
5)
Disconnect charging source prior to connecting or disconnecting the battery.
6)
Remove battery ground during installation and maintenance to reduce likelihood of shock.
•
Unplug the UPS prior to cleaning and do not use liquid or spray detergent.
•
Internal battery voltage is 12VDC. Sealed, lead-acid,6-cell battery.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Uninterruptible Power Supply
Page 5