Aqua Select 832405B Skrócona instrukcja obsługi - Strona 5
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Crossover Aqua Select 832405B. Aqua Select 832405B 9 stron.
Drukuj stronę• One step (32402B) should already be inside
the pool and weighted in place.
• Place second assembled step (832402B) on
outside of the pool, lined up with the step
placed inside the pool during step installation.
Make sure step is on level ground.
• Slide the assembled crossover down over the
upper handrail posts of the steps until
it is resting on the pool top rail. It may be
necessary to lubricate posts prior to installing
crossover.
CAUTION
5
STEP 3
STEP 4
DO NOT attempt to stand
on crossover until bridge is
fully assembled.
Center one of the lock caps (F) over any hole
•
on the side of the connecting rail.
Using a small rubber mallet or (a block of wood
•
and a small hammer), tap on the locking cap
until it is secured over the pin sticking through
the side of the connecting rail.
Repeat this procedure for each of the additional
•
openings. You will only need to use a total of
(4) lock caps.