Billion BiPAC 7800(N)X(L) Skrócona instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Modem Billion BiPAC 7800(N)X(L). Billion BiPAC 7800(N)X(L) 10 stron. 3g/4g lte (wireless-n) (vpn) adsl2+/ fibre broadband router
Również dla Billion BiPAC 7800(N)X(L): Instrukcja konfiguracji (10 strony), Instrukcja konfiguracji (11 strony)

Billion BiPAC 7800(N)X(L) Skrócona instrukcja obsługi
Billion BiPAC 7800(N)X(L) 3G/4G LTE (Wireless-N) (VPN) ADSL2+/ Fibre Broadband Router

Hardware Overview

The Front LEDs

When the system is ready,
the LED will be lit green; lit
red when the device fails to
boot or in emergency mode.
Lit when successfully connected
to an Ethernet device, lit green for
1000Mbps, Orange for 100Mbps,
and blinking when data is being
transmitted/ received.

The Rear Ports

Antennas only for
BiPAC 7800NX(L)
Connect your computer to a LAN port
with the Ethernet cable included.
E
E
W
W
A
A
N
N
:
:
I
I
t
t
o
o
for connecting to Cable Modem, VDSL,
fibre modem or PON optic lines with
RJ-45 cable.
*Note: For WPS configuration, please refer to the WPS section of User Manual.
BiPAC 7800NX(L) Only
Lit green when wireless
is enabled; unlit when
wireless is disabled.
Connect to the ADSL
/ telephone network
with RJ-11 cable
(telephone).
f
f
f
f
e
e
r
r
s
s
p
p
o
o
r
r
t
t
#
#
4
4
a
a
s
s
a
a
W
W
A
A
N
N
p
Lit red when WAN port fails to get IP
address; lit green when WAN port
gets IP address successfully. Unlit
when the device is in bridge mode
or WAN connection is absent.
BiPAC 7800NX(L) Only
Flash green when WPS
configuration is in
progress; unlit when
WPS fails.
Connect the supplied
Connect the USB
power adapter to this
cable on this port.
jack.
BiPAC 7800NX(L) Only
Push WPS button to
p
o
o
r
r
t
t
trigger Wi-Fi Protected
Setup function
3-
-
Flash green when the device is
establishing the active DSL link
; lit green when successfully
connected to an ADSL DSLAM,
("line sync"). Unlit when the DSL
link has not been established.
Press the "Reset" button
for 5 seconds and above
to restore the factory
default settings.
*
.
Power ON/OFF
switch.