DFM CFB16 Instrukcja obsługi - Strona 12

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Akcesoria do ciągników DFM CFB16. DFM CFB16 20 stron.

Rotating / Replacing Teeth

Rotating & Changing The Teeth

The carbide teeth should be rotated every 125 hours or

when cutting rate has noticeably decreased. Depending

on cutting conditions, the teeth may need to be rotated

sooner or later.

DO NOT RUN A CUTTING DISC WITH BROKEN OR

MISSING TEETH. AN UNBALANCED LOAD COULD

OTHERWISE OCCUR CAUSING EXCESSIVE WEAR ON

THE BEARINGS.

IF THE SAW IS OPERATED WITH A TOOTH MISSING,

THE BACKING BLOCK WILL WEAR QUICKLY. IF THE

BACKING BLOCK IS WORN, IT MUST BE CUT OFF

AND A NEW ONE WELDED ON.

Most wear occurs on the outside edge of the tooth.

A tooth needs to be rotated when cutting time has

noticeably increased. Rotate them 90° so that the top

edge faces out.

NOTE: When the tooth comes in contact with the

ground, the bottom edge will wear as well. If both the

bottom and outside edges of the tooth are noticeably

worn, rotate the tooth 180°.

The following signs indicate that the disc saw teeth

need to be replaced:

Damaged teeth

Missing segments of teeth

Unbalanced load

Worn cutting edges

A 1/4" hex bit socket and a ratchet are needed to

remove and fasten the teeth.

Note: Tighten to

TS3 Backing Block (BB-3439)

TS3 Carbide Cutting Tooth (TS1024)

TS3 Lock Washer (LW-1044)

TS3 Tooth Bolt (B1043)

± Torque

Rotating / Replacing Teeth | 6