AVS Electronics VECTOR Plus Instrukcja instalacji - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla System bezpieczeństwa AVS Electronics VECTOR Plus. AVS Electronics VECTOR Plus 12 stron. Bidirectional gsm interface

Drukuj stronę

Dialler programming to send "by command" SMS messages

To make a telephone dialler connected to VECTOR Plus activate SMS messages "by

command", the following steps are required:

1: program one of the telephone numbers of the dialler with the proper digits sequence

as explained hereon.

(0000nnTT)

2: associate to that telephone number some default communication protocol.

3: program the dialler to make one single calling attempt to that telephone number. If there are

repetitions, the SMS message will be sent many times.

4: program an output from the dialler or control panel to activate by a few seconds bringing to

negative "-" the "GSM" input terminal of the interface, while the telephone number is being

dialled.

NOTE 1: using AVS ELECTRONICS diallers or control panels, setting to "0" the number of attempts of

telephone calls will cause the dialler to make one single calling attempt.

NOTE 2: if the telephone number for SMS activation is not the first number "called" by the dialler, once the

"GSM" input terminal of VECTOR Plus has received the pulse to negative, all telephone calls previous to

the SMS activation number will be executed through the GSM channel, while successive ones will occur

over PSTN line.

Example:

Tel. numb 1: alarm telephone call

Tel. numb 2: alarm telephone call

Tel. numb 3: alarm telephone call

Tel. numb 4: SMS activation command

Tel. numb 5: alarm telephone call

Tel. numb 6: alarm telephone call

Call to #1

Call to #2

Call to #3

SMS cmd #4

Call to #5

Call to #6

GSM

PSTN line