DG NVMe-IP Instrukcje demonstracyjne - Strona 5
Przeglądaj online lub pobierz pdf Instrukcje demonstracyjne dla Płyta główna DG NVMe-IP. DG NVMe-IP 20 stron. Linux demo
Również dla DG NVMe-IP: Instrukcja (18 strony)
Drukuj stronędg_nvmeip_instruction_en.doc
2 Demo setup
1) Power off system.
2) DIP Switch setup.
a) For ZC706 board only,
i.
Set SW11="00000" to configure PS from JTAG, as shown in Figure 2-1.
ii.
Set SW4="01" to connect JTAG with USB-to-JTAG interface, as shown in Figure
2-2.
Figure 2-1 SW11 setting to configure PS from JTAG on ZC706 board
Figure 2-2 SW4 setting to use USB-to-JTAG on ZC706 board
b) For Zynq Mini-ITX board only,
i.
Set SW7="00000" to configure PS from JTAG, as shown in Figure 2-3.
ii.
As shown in Figure 2-4, install a jumper on JP1 pins 1-2 to enable JTAG chain.
Install the power module on the board via J8, J9, J10 connectors, and connect
power adapter cable to FPGA board via P2 connector.
Then, user can skip to Step 5) to setup NVMe SSD for Mini-ITX board.
Figure 2-3 SW7 setting to configure PS from JTAG on Zynq Mini-ITX
30-Nov-17
Page 5