Avsl qtx QR8PABT Podręcznik użytkownika - Strona 3

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla System głośników Avsl qtx QR8PABT. Avsl qtx QR8PABT 5 stron. Portable pa

Drukuj stronę

Control panel

Powering up

Your new QRPABT unit may arrive with you with the internal battery charged. Before connecting to the mains with the

supplied power adaptor, switch the unit on and check the POWER LED. If it is green, there is charge in the battery. If it is

red, then you will need to charge the battery before using away from a mains supply

Connect the QRPABT unit to the mains using the supplied power adaptor. You may otherwise opt to connect the DC input

jack to an external 12-15Vdc supply, such as a car battery, or use the internal battery if charged.

When not in use but connected to the mains, if the POWER switch is in the

charged from the mains supply. This can be observed by the CHARGE LED which will light orange when charging. When

fully charged, the CHARGE LED will change to green.

Note: it is recommended to store the PA unit at an ambient temperature and not with the battery fully discharged.

Initial setup

Turn all VOLUME & ECHO controls down (anti-clockwise) and turn the POWER switch on (the power LED should light).

BASS and TREBLE controls should remain pointing vertically (12-o-clock position). Turn up the main VOLUME control part

way and switch VCV off. Your QRPABT unit should now be ready to operate.

VHF Microphone

Insert the supplied AA batteries into the handheld microphone by carefully unscrewing the base and connecting the "+"

and "-" terminals or the battery to the corresponding contacts inside the microphone body, taking care to observe the

correct polarity.

Turn the VHF VOL control up (clockwise) part way.

Switch on the wireless mic – the RF LED should light as a result. If the LED on the transmitter lights dimly, change the

battery. Gradually increase the VHF VOL control, testing the microphone for output through the speaker. Take care not to

incur "feedback" (howling or screeching sound through the speaker) by keeping the microphone a sensible distance from

the speaker and pointing away from the speaker so that it doesn't

Turning the ECHO control clockwise introduces a pre-set echo function for singing and special effects. BASS and TREBLE

can be cut by turning anti-clockwise or boosted by turning clockwise.

When not in use, switch the beltpack transmitter off and remove the batteries if not being used for long periods.

USB port

SD/MMC card slot

ECHO level

Wired MIC / guitar volume

TREBLE EQ

VHF Mic volume

LINE IN 2 x RCA

VCV talkover on/off

Wired MIC.1 / guitar input 6.3mm jack

Wired MIC.2 input 6.3mm jack

Smart phone / aux input stereo 3.5mm jack

DC power input jack

Media player LCD display & IR receiver

Media player mode & transport controls

BASS EQ

Main volume

VHF wireless receiver on/off

MIX OUT line output 2 x RCA

Power on/off

Fuse holder

Battery charge & power LEDs

off

position, the internal battery will be re-

hear

the speaker output.

178.838UK, 178.839UK User Manual