CPS IAQPRO SmartAir Skrócona instrukcja obsługi i rozwiązywania problemów - Strona 2
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi i rozwiązywania problemów dla Przyrządy pomiarowe CPS IAQPRO SmartAir. CPS IAQPRO SmartAir 8 stron. Professional indoor air quality meter
Również dla CPS IAQPRO SmartAir: Instrukcja obsługi (18 strony), Instrukcja obsługi (9 strony)
Drukuj stronę
CONTENTS
GENERAL SAFETY & STORAGE INSTRUCTIONS
QUICK START INSTRUCTIONS
AIR QUALITY (Issues, Causes, Solutions)
TROUBLESHOOTING GUIDE
APPENDIX (SmartAir Sensor Specifications)
GENERAL SAFETY & STORAGE INSTRUCTIONS
Please read, follow and understand the contents of this entire manual, with special attention
given to warning statements.
FOR USE BY PROFESSIONAL OPERATORS ONLY.
WARNING: The SmartAir is NOT a life-safety device and does NOT provide absolute
values for all indoor airborne solids, liquids or gases that may be detected.
It does NOT replace the capability of existing Smoke Alarms, Carbon
Monoxide Alarms, Heat Detectors or any other dedicated life safety devices
intended for use in residential or commercial environments.
The SmartAir does NOT provide audible alarms for CO2, VOC's, PM
PM
STORAGE NOTE: THIS DEVICE IS A PRECISION INSTRUMENT AND IT IS STRONGLY
RECOMMENDED TO ALWAYS STORE IT INSIDE UNDER NORMAL
TEMPERATURE AND HUMIDITY CONDITIONS. If the IAQPRO has been
stored in temperature extremes, it must be placed indoors, unplugged
in NORMAL TEMPERATURE AND HUMIDITY conditions for 6 to 8 hours
before being powered ON.
QUICK START INSTRUCTIONS
SETTING THE tVOC SENSOR BASELINE (Approximately 24 Hours, 5 Minutes Required)
•
User must set the tVOC sensor baseline PRIOR TO INITIAL USE.
•
Follow instructions below or connect unit to CPS Link App for online guidance.
•
Unit does NOT need to be connected to app during the initial 24 hrs. time period (Step
1- 2).
•
Unit must be connected to CPS Link app to complete Step 3.
Step 1: (24 Hours Required) Select a secure location INDOORS, plug unit into power
source to turn ON and allow it to run for 24 consecutive hours. Light bar will initially
turn RED, then alternate Green/Red during this time period.
2
, Relative Humidity, Temperature, Building Pressure or Dew Point.
10
2
2-4
5-6
6-7
7
,
2.5
+