DGF Fabrications N2 Instrukcja instalacji i konserwacji - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja instalacji i konserwacji dla Kominek wewnętrzny DGF Fabrications N2. DGF Fabrications N2 14 stron. Gas effect fires (natural gas & lpg) for decorative purposes only
Drukuj stronęThis appliance must be hearth mounted in a builders opening or under an associated independent
•
canopy or a fireplace recess.
On no account must this appliance be sited on combustible materials or carpets. It is not suitable for
•
combustible walls.
When the appliance model has been supplied or specified with support legs, the appliance must be
•
screwed firmly to the hearth. In the case of freestanding basket models care should be taken to secure
the burner to the given basket. In most cases the burners for free standing models would have been
made to ensure a correct and tight fit.
Ensure that the burner tray fits neatly into the intended location, and that you have easy access to the
•
controls
Ensure there is adequate airflow to the underside of the fire (through the fire front or fret etc). This
•
airflow is required for cooling the underside of the fire and controls, as well as to provide the primary
combustion air.
For fires with a manual control valve a minimum primary air inlet of 100sq cm is usually enough
•
If a fireplace is properly designed and installed the controls will not overheat – it is the
•
installer's responsibility to ensure that the installation does not allow the controls to
overheat.
Hole in the wall fires must be placed 100mm or more back from the front opening.
From the top of simulated coal, pebbles, logs or driftwood to top of opening must be no more than 450mm. if
this is the case canopy will need to be fitted.
No hearth is required if hole in wall is 250mm off floor level.
Units 1-3 Vulcan St, Edward St Industrial Estate, Darlington. DL1 2UL – Tel: 01325 281304; Fax: 01325 481889
APPLIANCE LOCATION
HOLE IN THE WALL
6
DGF Fabrications;