Allied Telesis Rapier Series Rozwiązywanie problemów
Przeglądaj online lub pobierz pdf Rozwiązywanie problemów dla Router sieciowy Allied Telesis Rapier Series. Allied Telesis Rapier Series 5 stron. How to set up pppoe between a linux client and access concentrator
Również dla Allied Telesis Rapier Series: Instrukcja rozwiązywania problemów (8 strony), Uwaga dotycząca wydania (8 strony), Jak skonfigurować (9 strony), Jak to zrobić (8 strony)
Drukuj stronę
Best Practice |
Introduction
This How To Note describes techniques for on-site debugging. It is in no way intended to be
a comprehensive guide to debugging Allied Telesis equipment. Instead, it is aimed at passing
on some techniques that have been found to be useful. Particularly, this document describes
techniques which:
make it less likely that you will miss important pieces of information
make it simpler for someone else to analyse the debug information that you capture
enable you to be more accurate in after-the-event discussions of what you saw.
Which products does it apply to?
This document applies to the following Allied Telesis routers and managed layer 3 switches:
AR300, AR400, and AR700 series routers
AT-8600, AT-8700XL, AT-8800, Rapier, and Rapier i series switches
AT-9800 series switches
AT-8900, AT-9900, and AT-9900s series switches
x900 series switches
SwitchBlade series switches
Related How To Notes
You also may find the following How To Notes useful, because they specifically discuss how to
debug connections:
How To Troubleshoot ISDN Connections
How To Troubleshoot VPNs
Note that many other How To Notes include troubleshooting information as well as
configuration examples.
How To Notes are available from www.alliedtelesis.com/resources/literature/howto.aspx.
C613-16028-00 REV B
On-Site Debugging
www.alliedtelesis.com