Dell D420 - Latitude Notebook Computer Instrukcja serwisowa - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja serwisowa dla Laptop Dell D420 - Latitude Notebook Computer. Dell D420 - Latitude Notebook Computer 38 stron.

Drukuj stronę

memory module

NOTICE:

Insert memory modules at a 45-degree angle to prevent damage to connectors.

NOTE:

If the memory module is not installed properly, the computer may not boot properly. No error message indicates this failure.

5. Ground yourself and install the new memory module:

a. Align the notch in the module edge connector with the tab in the connector slot.

b. Slide the module firmly into the slot at a 45-degree angle, and rotate the module down until it clicks into place. If you do not feel the click, remove

the module and reinstall it.

6. Replace the memory/Mini-Card module cover and tighten the three captive screws.

7. Insert the battery into the battery bay, or connect the AC adapter to your computer and an electrical outlet.

8. Turn on the computer.

As the computer boots, it detects the additional memory and automatically updates the system configuration information.

To confirm the amount of memory installed in the computer, click Start® Help and Support® Dell System Information.

Mini-Cards

CAUTION:

Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.

NOTICE:

To prevent damage to the system board, remove the main battery before you service the computer.

1. Follow the procedures in

Before You

2. Turn the computer upside down and loosen the three captive screws on the memory/Mini- Card module cover and remove the cover.

NOTE:

Cable routing for the Mini-Cards may vary.

Wireless Local Area Network (WLAN) Cards

1. If a WLAN card is not already installed, go to

securing clips (2)

Begin.

step

2. If you are replacing a WLAN card, remove the existing card: