Dell Inspiron 1090 Instrukcja serwisowa - Strona 35

Przeglądaj online lub pobierz pdf Instrukcja serwisowa dla Laptop Dell Inspiron 1090. Dell Inspiron 1090 47 stron.
Również dla Dell Inspiron 1090: Instrukcja serwisowa (47 strony)

Drukuj stronę
Dell Inspiron 1090 Instrukcja serwisowa
Back to Contents Page
  Wireless Mini-Card(s)
Dell™ Inspiron™ 1090 Service Manual 
  Removing the Mini-Card(s)
  Replacing the Mini-Card(s)
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
 
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ 
is not covered by your warranty.
 
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
 
CAUTION:
To help prevent damage to the system board, remove the main battery (see
computer.
NOTE:
Dell does not guarantee compatibility or provide support for Mini-Cards from sources other than Dell.
If you ordered a wireless Mini-Card with your computer, the card is already installed.
Your computer has one full Mini-Card slot and one half Mini-Card slot:
 One full Mini-Card slot — supports Wireless Wide Area Network (WWAN).
l
 One half Mini-Card slot — supports Wireless Local Area Network (WLAN) or Worldwide Interoperability for Microwave Access (WiMax).
l
NOTE:
Depending on the configuration of the computer when it was sold, the Mini-Card slot may or may not have a Mini-Card installed.
 Removing the Mini-Card(s)
 
1. Follow the instructions in
Before You
 
2. Remove the label door (see
 
3. Remove the keyboard (see
 
4. Remove the palm-rest assembly (see
 
5. Remove the battery (see
Removing the
 
6. Disconnect the antenna cables from the Mini-Card(s).
 
7. Remove the screw that secures the Mini-Card(s) to the system board.
1 antenna cables (2) 2 Mini-Card
3 screw
4 system-board connector
 
8. Lift the Mini-Card(s) out of the system-board connector.
Begin.
Removing the Label
Door).
Removing the
Keyboard).
Removing the Palm-Rest
Battery).
Removing the
Assembly).
Battery) before working inside the