Dell Inspiron 600m Instrukcja serwisowa - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja serwisowa dla Laptop Dell Inspiron 600m. Dell Inspiron 600m 41 stron. Hard drive
Również dla Dell Inspiron 600m: Zacznij tutaj (2 strony), Zacznij tutaj (2 strony), Zacznij tutaj (2 strony), Podręcznik dla początkujących (2 strony), Podręcznik użytkownika (34 strony), Instrukcja konfiguracji (2 strony), Pierwsze kroki (2 strony), Instrukcja konfiguracji (2 strony), Instrukcja konfiguracji (2 strony), Instrukcja konfiguracji (2 strony), Instrukcja konfiguracji (2 strony), Instrukcja konfiguracji (2 strony), Instrukcja konfiguracji (2 strony), Instrukcja konfiguracji (2 strony), Instrukcja serwisowa (41 strony), Podręcznik użytkownika bazy multimedialnej (26 strony), Instrukcja serwisowa (40 strony), Instalacja i konfiguracja (38 strony), Szybki start (2 strony), Szybki start (2 strony), Szybki start (2 strony), Konfiguracja komputera (2 strony), Instrukcja serwisowa (41 strony), Instrukcja serwisowa (4 strony)

Drukuj stronę
Dell Inspiron 600m Instrukcja serwisowa
Back to Contents Page

Before You Begin

Dell™ Inspiron™ 500m Service Manual
  Preparing to Work Inside the Computer
  Recommended Tools
  Computer Orientation
  Screw Identification
Preparing to Work Inside the Computer
 
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell is
not covered by your warranty. Read and follow the safety instructions in the Owner's Manual that came with the computer.
 
CAUTION:
To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of
your computer's electronic components. You can do so by touching an unpainted metal surface.
 
CAUTION:
Handle components and cards with care. Do not touch the components or contacts on a card. Hold a card by its edges or by its metal
mounting bracket. Hold a component such as a microprocessor by its edges, not by its pins.
 
NOTICE:
To avoid damaging the computer, perform the following steps before you begin working inside the computer.
1.  Ensure that the work surface is flat and clean to prevent scratching the computer cover.
2.  Save any work in progress and exit all open programs.
3.  Turn off the computer and all attached devices.
 
NOTE:
Ensure that the computer is off and not in a power management mode. If you cannot shut down the computer using the computer operating
system, press and hold the power button for 4 seconds.
4.  If the computer is connected to a docking device (docked), undock it.
5.  Disconnect the computer from the electrical outlet.
6.  To avoid possible damage to the system board, wait 10 to 20 seconds and then disconnect any attached devices.
7.  Disconnect all other external cables from the computer.
8.  Remove any installed PC Cards from the PC Card slot.
9.  Close the display and turn the computer upside down on a flat work surface.
 
NOTICE:
To avoid damaging the system board, you must remove the main battery before you service the computer.
10.  Slide and hold the battery-bay latch release on the bottom of the computer, and then remove the battery from the bay.
 
11.  Remove any installed
memory
12.  Remove the
hard
drive.
modules,
Mini PCI
cards, and devices, including a second battery if one is installed.