Craden DP9 Podręcznik wsparcia technicznego - Strona 19

Przeglądaj online lub pobierz pdf Podręcznik wsparcia technicznego dla Drukarka Craden DP9. Craden DP9 19 stron. Transaction printers
Również dla Craden DP9: Podręcznik techniczny (8 strony), Instrukcja instalacji (2 strony), Podręcznik użytkownika (18 strony)

Drukuj stronę
Is the display on the printer blank?
No
Do the keys on the keypad work?
See page 13 for functions and
exercise keys
Yes
Will the printer take a document
when it is placed into the machine?
Yes
Does the carriage move when printer
should be printing? Open cabinet
and override cover open sensor
using 99 FUNCT (pg. 4)
Yes
Does the printer print? Insert paper
and press 900 FUNCT on the
keypad (pg. 15)
Yes
Is the printed output smearing?
No
Is the printed output too light?
No
Do the rollers run continuously, even
when paper is not in the printer?
No
Is the printed output spaced
correctly?
Yes
Does the printer communicate with
the system when you send a
transaction?
End

DIAGNOSTIC FLOWCHART

Use this flow chart to assist in troubleshooting.
 Power switch is ON
 Power cord plugged in both ends
 Contrast knob adjusted (pg. 14)
Yes
 Power outlet is live
No
 Is the keypad locked? (pg. 14)
 Press EJECT & CLEAR and try again
 Insert paper, press A key (see printer parameter,
No
 Check sensors (pg. 12)
 Carriage Fault on display? Foam packing removed?
 Insert paper, press A key (see printer parameter, BEGIN
No
 Ribbon correctly installed? (pg. 5)
 Ribbon shield installed correctly? (pg. 6)
 Remove ribbon, check for jammed cartridge
 Check that ribbon knob turns as carriage moves
No
 Ribbon correctly installed? Ribbon worn out? (pg. 5)
 Ribbon shield installed correctly? (pg. 6)
Yes
 Document too thick?
 Printing in non-printable area of a document or passbook?
 Ribbon correctly installed? Ribbon worn out? (pg. 5)
 Remove ribbon, check for jammed cartridge
Yes
 Ribbon shield installed correctly? (pg. 6)
 Quiet mode set to Y? Darkness set too low? (pg. 4)
 Does the ribbon knob turn as carriage moves?
 Ribbon guide plate pushed up completely? (pg. 6)
Yes
 Paper dust or debris inside printer. (pg. 13)
 Blow out debris with compressed air.
 Multisensor cable seated correctly? (pg. 13)
 Characters per inch setting OK? (see printer parameter,
No
 Check all service parameters. (pg. 4)
 Check interface cable mounting (pg. 3)
 Communication parameters match host system? (pg. 3)
No
DOCUMENT INSERT, pg. 4)
PRINTING, pg. 4)
LINES/INCH, pg. 4)
18