Dell Studio 1435 Instrukcja serwisowa - Strona 28
Przeglądaj online lub pobierz pdf Instrukcja serwisowa dla Laptop Dell Studio 1435. Dell Studio 1435 42 stron. Notebook dell studio 1435
Drukuj stronęBack to Contents Page
Memory
Dell Studio™ 1435 Service Manual
Removing the Memory Module(s)
Replacing the Memory Module(s)
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions that shipped with your computer.
You can increase your computer memory by installing memory modules on the system board. See "Specifications" in your Setup Guide for information on the
memory supported by your computer. Install only memory modules that are intended for your computer.
NOTE:
Memory modules purchased from Dell are covered under your computer warranty.
Your computer has two user-accessible SODIMM sockets that can be accessed from the bottom of the computer. The DIMM B memory module is located directly
above the DIMM A memory module located on the bottom of the computer.
NOTICE:
If you need to install memory modules in both connectors, install a memory module in the lower connector before you install a module in the
upper connector.
Removing the Memory Module(s)
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as a connector on the back of the computer).
1. Follow the procedures in
Before You
2. Turn the computer over and remove the base cover (see
NOTICE:
To prevent damage to the memory module connector, do not use tools to spread the memory module securing clips.
3. Use your fingertips to carefully spread apart the securing clips on each end of the memory module connector until the module pops up.
4. Remove the memory module from the connector.
1
memory module connector
3
memory module
Replacing the Memory Module(s)
NOTICE:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as a connector on the back of the computer).
1. Align the notch in the module edge connector with the tab in the connector slot.
2. Slide the module firmly into the slot at a 45-degree angle, and press the module down until it clicks into place. If you do not feel the click, remove the
module and reinstall it.
NOTE:
If the memory module is not installed properly, the computer may not boot.
Begin.
Removing the Base
2
securing clip (2)
Cover).