Dell 3250 Instrukcja obsługi produktu - Strona 24

Przeglądaj online lub pobierz pdf Instrukcja obsługi produktu dla Pulpit Dell 3250. Dell 3250 37 stron. Product guide (.pdf)
Również dla Dell 3250: Aktualizacja informacji (32 strony), Instrukcja obsługi (39 strony), Instrukcja obsługi (39 strony), Skrócona instrukcja obsługi (2 strony)

Debug Methodology and Failure Isolation

8.1

If the memory test finds any bad DIMM(s) (defined as mismatched DIMMs within a row, multi-bit

errors [MBE] detected within a DIMM, single-bit [SBE] non-transient errors within a DIMM), the

entire associated row will be mapped out and autoscan will not include any memory that is

mapped out. The memory test can isolate persistent or non-transient single-bit and multi-bit

errors to the defective DIMM and will make that information available.

If mismatched or bad DIMMs are found during the initial geometry check, the bad row will be

logged to the System Event Log (SEL). If both rows are determined to be bad, the system will

not boot, and the bad row(s) will be logged to SEL. Additionally, the system will emit beep codes

as documented in the post and error codes section.

Assuming that there is at least one good row, the bad row will be reported as an error when

video is available will be logged to the SEL, and the system will continue to boot.

8.1.1

Remove memory DIMM, look for bent pins or obvious sign of contamination on DIMM or inside

DIMM site - Reseat the memory; swap ROW one with ROW two (2

reconfigure to minimum memory configuration (4 DIMMs in one ROW, DIMM sites 1,2,3,4 must

be populated at a minimum).

Note: Even though DIMMs are numbered and populated consecutively, DIMM Sites are not

physically consecutive. Refer to the silkscreen on the

DIMMS in order below.

DIMM Sites 1=J9J3, 2=J9J1, 3=J9D3, 4=J9D1 FIRST. Sites 5=J9J2, 6=J8J1, 7=J9J2, 8=J8D1

are optional.

Exchange the memory, one ROW at a time, with a complete set of known good memory. If

failure symptoms persist, suspect the motherboard. If it passes, replace the suspect memory,

one at a time, into their original sockets, until the Failure recurs (if replaced one by one - DDR

must be same size, die and vendor).

8.1.2

DDR266 memory can be replaced, one by one, with same mfg P/N (same size, die and vendor)

A complete row must be replaced in sets of 4 (minimum config is 4 x 256= 1GB). Populate

DIMM Sites 1=J9J3, 2=J9J1, 3=J9D3, 4=J9D1 FIRST. Sites 5=J9J2, 6=J8J1, 7=J9J2, 8=J8D1

are optional. If failure persists replace the main board.

Intel® Server Platform SR870BH2

set of 4 DIMMS)

near each DIMM site – first 4

main board

Revision 1.1