ENSOTECH SWAVE-E2 Podręcznik - Strona 9

Przeglądaj online lub pobierz pdf Podręcznik dla Kable i złącza ENSOTECH SWAVE-E2. ENSOTECH SWAVE-E2 11 stron. Electronic speed controller
Również dla ENSOTECH SWAVE-E2: Podręcznik użytkownika (11 strony)

Drukuj stronę

SENSORS RECOGNITION SYSTEM

Swave E ESC has sensors recognition system. So, if you connect sensor cable to ESC the hall sensors icon will still

grey. Then if you push throttle with connected sensor cable and all is correct sensors icon becomes blue. If something

is wrong ESC detects the error and show warning icon, also, red led will ON

Initial sensor connection or sensorless

mode

ESC LED INDICATION

Red

led is failure indicator, there are several events that may cause red LED turn on.

Throttle receiver is disconnected or was not calibrated –

Cut Off issue occurs –

RED

Protection issue occurs –

Sensor issue occurs –

RED

Blue

led indicates the status of the device, if it is constant ON or blinks your device works normal otherwise try to

update it. If Update does not help, connect our support team: [email protected] or contact your dealers.

Turbo timing advance and Boost timing advance are BOTH zero –

REGISTERED TRADEMARK

ENSOTECH is registered trademarks of Ensotech Limited.

All other brands mentioned in this guide are protected by copyright being the property of their respective owners.

SAFETY PRECAUTIONS AND MAINTENANCE

-Not for children under 14 years old. This is not a toy.

-Swave needs NO external capacitors or any other rework.

-Use Ensotech certified sensored motor with Ensotech Brushless ESC for best performance and protection.

-Using a not approved sensored motor may result in excessive current draw due to advance motor timing and may

cause severe ESC damage that will not be covered by product's warranty!

- Swave ESC is a high end racing product that offers many customized parameters. If you are not certain about any of

the settings, contact your dealer for assistant or contact us.

-Do not overload motor due to incorrect/high gear ratios. Make sure the gear mesh is set properly. If the mesh is too

loose it can cause motor and ESC overheat which will damage the ESC and motor.

Working on sensor mode

LED blinks

RED

LED is constant ON

LED blinks

RED

LED is constant ON

BLUE

led blinks otherwise it is constant ON

Error with sensor