ensto ECOAC44 Instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Urządzenie zabezpieczające ensto ECOAC44. ensto ECOAC44 8 stron.

Drukuj stronę

2.4

Sätt skyddskragen och termostatens fästplåt mot apparatdosan så att öppningarna för doss-

kruvarna kommer på varandra.

2.5

Tryck skyddskåpan på termostaten enligt. fig. 2.

2.6

Fäst termostaten och skyddslockskombinationen med dosskruvarna.

2.7

Tryck skruvskyddskivan samt fäst termostatens frontplatta och ratt på plats.

2.8

Tag termostaten ibruk enligt termostatens bruksanvisning.

3. RITNINGAR

Skyddskragen PMR637 och ledningarna till termostaten.

Täckskivans, skyddslockets och skruvskyddskivans fastsättning i termostaten.

ENG

PROTECTIVE CASE ECOAC44 (IP44) FOR THERMOSTAT ECO10F / ECO16FR

ECOAC44 is intended for use as a protective case for the ECO10F or ECO16FR thermostat. The protective

case allows the thermostat to be installed in rooms subject to dampness, where the safety distances

stated in the electrical safety regulations demand a casing class of IP44. The protective case is sui-

table for use as a cover for a single appliance socket, but not for groups of more than one appliance.

1. BEFORE INSTALLATION

1.1

Check that the safety distances meet the requirements of the safety regulations.

1.2

Check that you have all the components and tools needed for installation. The package inclu-

des a watertight collar PMR637, a cover plate with a transparent watertight flap, a screw protector

plate, and this installation instruction.

2. INSTALLATION

2.1

Install the thermostat sensor cable in the protective conduit.

2.2

Feed the leads to the thermostat through the watertight collar PMR637, as shown in Figure 1.

2.3

Connect the thermostat to the mains power supply, the sensor cable, and the load, according

to the thermostat instructions.

2.4

Set the watertight collar and the thermostat installation plate screw holes in position.

2.5

Push the cover plate and watertight flap assembly onto the thermostat, as shown in Figure 2.

2.6

Use the screws to secure the thermostat and cover assembly to the socket.

2.7

Set the screw protector plate in place and install the thermostat cover and button.

2.8

Start the thermostat according to the thermostat installation instructions.

3. ILLUSTRATIONS

Leads running through watertight collar PMR637.

Installation of cover plate, watertight flap, and screw protector plate on the thermostat.