DH Lifelabs Aaira Mini Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Oczyszczacz powietrza DH Lifelabs Aaira Mini. DH Lifelabs Aaira Mini 8 stron.
Również dla DH Lifelabs Aaira Mini: Skrócona instrukcja obsługi (4 strony)

Drukuj stronę

Operating Procedures

Press the On/Off button to turn the air purifier on. A start-up sound will play and

all the indicators on the control panel will turn on for 3 seconds.

The On/Off button will be illuminated white, indicating that the purifier is in

standby mode.

Press the On/Off button again to begin operation. The blue light in the water

tank will turn on, the fan speed will default to level 2, and the Sterilize button will

illuminate, indicating that the sterilizer is actively disinfecting the air in the room.

Press the fan speed button to toggle the fan speed between sleep, 2, and 3

speeds. When sleep mode is selected, fan speed is reduced and the blue light

inside the water tank will turn off.

Press the power On/Off button again to turn the purifier off.

Timer Operation

Press the timer button to toggle through the options (2H-4H-8H-None). Once selected,

an internal timer controls operation of the purifier for the selected duration. Once the

timer expires the purifier enters standby mode.

NOTE: Do not use this option if you want the sterilizer to run continuously.

CEF Replacement

Remove the CEF lid.

Unscrew the CEF from the tank and discard. NOTE: Handle the new CEF by the end

caps to avoid touching the element, this will prevent possible contamination of the

filter element.

Remove the replacement CEF from packaging and screw it into the bottom of the

water tank. Plug in the power cord.

Turn on the Sterilizer and press and hold the Sterilize button for three seconds to reset

the filter life countdown.

If you replace the filter before the accumulated life time is reached, the filter life timer

cannot be reset. To purchase replacement filters, please visit: www.dhlifelabs.com

Troubleshooting

Symptom

Probable Cause/Solution

Check that Pre-Filter and the air inlet are free from obstructions

Low air flow

and not blocked by dust, trash, etc. Clean as necessary.

Emits a chlorine

Chlorine smell is normal. You can change to sleep mode to

(disinfection) smell

minimize the smell in the room.

Air from the Sterilizer

Check that water tank and CEF are clean. Clean water tank

smells bad

regularly and replace CEF as necessary.

Immediately unplug the power cord. Lift up the Sterilizer and

The Sterilizer has been

wipe off any water on the surface of the machine. Allow the

tipped over or fallen

Sterilizer to completely dry before resuming operation.

Water added to Water

Please discard all water in the tank and check again. If it still

Tank, and water level

does not work, contact Customer Assistance.

indicator is still flashing

It takes some time to dissolve the salt and monitor the actual

Salt Level indicator

concentration. If it still does not work after some time, discard

displayed even after salt

salt water solution and mix a new batch per the instructions

has been added

carefully.

Salt Level indicator

Make sure amount of salt added is correct. If necessary discard

flashing after salt has

salt water solution and mix a new batch per the instructions

been added

carefully.

For any issues not covered here, contact Customer Assistance.